Abstract:Due to non-condensable gas under conditions of vacuum and low temperatures, it becomes difficult to obtain precise vapor pressures of typical liquid desiccants by an experiment. Usually, non-condensable gas is removed by a traditional degassing method (degassing after prepared solutions - DPS), in which prepared liquid desiccants are circularly frozen and non-condensable gas is pumped out. However, the solvent of liquid desiccants could greatly evaporate during traditional degassing processes. Concentrations of the prepared liquid desiccants could be greatly deviated from those of the prepared liquid desiccants. Accordingly, measured vapor pressures usually greatly deviate from those corresponding to the concentrations of the prepared liquid desiccants. Moreover, it becomes very difficult to determine new concentrations of the prepared liquid desiccants after degassing, precisely. To overcome the challenges for precise measurements of typical liquid desiccants, a novel technique is developed in this context. The new method is called DSSPS (degassing solvents and solutes before preparing solutions - DSSPS), in which degassed solvent and solute is weighted respectively, and then, is mixed as measured solutions. Thus, concentrations of the measured solutions could be determined easily and precisely. Vapor pressures of LiCl-H2O desiccants are measured by the new method at a range from 218K to 258K and with the mass fractions of solutions from 5% to 20%. Totally, 35 sets of vapor pressure are measured. Then, the data is correlated based on Antoine equation. The ARD% (Absolute Relative Deviation - ARD) of equation is from 0.04% to 3.21% and AARD% (Average Absolute Relative Deviation - AARD) is 1.73%. So, the new method could be used to measure vapor pressure of aqueous solutions at vacuum and low temperatures precisely. The average error between experimental data and the results calculated by EES (Engineering Equation Solver - EES) is within 15.2%, and its maximum error is 35.46%. Vapor pressure data in this context also provides important reference for development of a precise calculation model.

Measurement Method of Compressibility Coefficient for Tridecane with A Vibrating Tube Densimeter

Measurement Method of Compressibility Coefficient for Density Standard Liquid at 2329 Kg/M(3) with A Vibrating Tube Densimeter

Measurement of Saturated Vapor Pressure and Compressed Liquid Density for 1,1,1,3,3,3-Hexafluoroisopropylmethyl Ether

Measurement Method of Compressibility and Thermal Expansion Coefficients for Density Standard Liquid at 2329 Kg/M(3) Based on Hydrostatic Suspension Principle

Diffusion measurements of isopentane, 1-hexene, cyclohexane in polyethylene particles by the intelligent gravimetric analyzer

Measurement of bubble points, dew points and critical points of carbon dioxide/vinyl chloride binary system

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

VAPOR PRESSURE MEASUREMNET OF LIQUID DESSICANTS AT LOW TEMPERATURES BY A NOVEL TECHNIQUE

Development and Stability Verification of a Measuring Installation of Saturation Liquid Density

Measurements of Isobaric Heat Capacity of R143a and R227ea at Liquid Phase by Quasi-Steady Scanning

Measurement and Modeling of the Densities for Co2 + Dodecane System from 313.55 K to 353.55 K and Pressures Up to 18 Mpa

Experimental Study of Pvtx Properties in the Gas Phase for Binary Mixtures of Dme and Hfc-134a

Simultaneous measurement of the density and viscosity for n-Decane + CO2 binary mixtures at temperature between (303.15 to 373.15) K and pressures up to 80 MPa

Precision measurement method of compression coefficient for density standard liquid close to single crystal silicon

Liquid density of binary mixtures of n -pentane and n -dodecane at temperatures from 283K to 363K and pressures up to 100MPa

Measurement and Modeling of Excess Molar Volume and Excess Enthalpy of n-Tridecane or n-Tetradecane with Decalin by Application of PFP Theory

Validation of an accurate vibrating-wire densimeter: Density and viscosity of liquids over wide ranges of temperature and pressure

Oil-water two-phase flow measurement based on differential pressure

PvT properties of heptane, octane, nonane, decane, thiophene, and eugenol at temperatures between (313 and 363) K and pressures up to 25 MPa comparing three calibration methods

Volumetric behaviour of (carbon dioxide + hydrocarbon) mixtures at high pressures

Densities and Volumetric Characteristics of Binary System of CO2 + Decane from (303.15 to 353.15) K and Pressures Up to 19 MPa