Abstract:The physical mechanism of flow unsteadiness is one of the key problems in cavitating flow. Significant efforts have been exerted to explain the cavitation-vortex interaction mechanism. As well, the process of kinetic energy transport during the evolution of unsteady cavitating flow must be elucidated. In this work, 2D calculations of cavitating flow around a NACA66 hydrofoil were performed based on the open source software OpenFOAM. The modified shear stress transport k-ω turbulence model, which considers curvature and turbulent eddy viscosity corrections, was employed to close the governing equations. The Schnerr-Sauer cavitation model was adopted to capture the cavitation phase change process. Numerical results showed reasonable consistency with the results of the experiments conducted by Leroux et al. (2004). The results showed that cavitation promotes turbulence intensity and flow unsteadiness around the hydrofoil. During the attached sheet cavity growth stage, high-value regions of turbulent kinetic energy are located substantially at the interface of the cavity, particularly at the rear portion of the cavity region. During the cloud cavity shed-off stage, the cavity begins to break off and the maximum value of turbulent kinetic energy is observed inside the shed cavity. Finally, the influence of cavitation on the turbulence intensity is illustrated using the turbulent kinetic energy transport equation, which shows that the pressure diffusion and turbulent transport terms dominate as cavitation occurs. In addition, cavitation promotes turbulence production and increases dissipation with fluid viscosity and flow unsteadiness. The viscous transport term only acts in the cavitation shedding stage under large-scale vortex shedding. Overall, these findings are of considerable interest in engineering applications.

A Turbulent Two-Phase Model for Predicting Cavitating Flow Based on Homogenous Nucleation Theory

A new cavitation model based on evaporation and condensation theory

Cavitation model with non-condensable gas effect and its numerical simulation

Numerical Simulation of Cavitation Flow under High Pressure and Temperature

Analysis of Two-Phase Cavitating Flow with Two-Fluid Model Using Integrated Boltzmann Equations

Modeling Cavitation Flow of Cryogenic Fluids with Thermodynamic Phase-Change Theory

A Pressure-Based Algorithm for Cavitating Flow Computations

Analysis of Ventilated Cavitation Around A Cylinder Vehicle with Nature Cavitation Using A New Simulation Method

Numerical simulations of cavitating water jet by an improved cavitation model of compressible mixture flow with an emphasis on phase change effects

Modeling liquid hydrogen cavitating flow with the full cavitation model

A Transport Equation Model for Simulating Cavitation Flows in Miniature Machines

Eulerian–Lagrangian modeling of spray G atomization with focus on vortex evolution and its interaction with cavitation

A Thermodynamic Cavitation Model Applicable to High Temperature Flow

Cavitating Turbulent Flow Simulation in a Francis Turbine Based on Mixture Model

NUMERICAL INVESTIGATION OF THE VENTILATED CAVITATING FLOW AROUND AN UNDER-WATER VEHICLE BASED ON A THREE-COMPONENT CAVITATION MODEL

Investigation of the cavitation model in an inducer for water and liquid nitrogen

Calculation of Cavitation Evolution and Associated Turbulent Kinetic Energy Transport Around a NACA66 Hydrofoil

Cavitation Simulation with Consideration of the Viscous Effect at Large Liquid Temperature Variation

CAVITATION MODEL VERIFICATION AND VALIDATION FOR WATER AND LIQUID NITROGEN IN AN INDUCER

A Cavitation Model Considering Thermodynamic and Viscosity Effects

On the Validation of the Cavitation Model Considering the Thermodynamic Effect of Cavitating Flow