Abstract:Piezoelectric devices based on high-temperature stable single crystals are of increasing interest due to a wide range of potential applications, such as actuators and resonant gravimetric sensors. The latter require highly accurate resonant-frequency measurements at temperatures as high as 1000 °C, and this can only be achieved with narrow resonance peaks and correspondingly low acoustic loss at these temperatures. Relevant atomistic defects in langasite (La 3 Ga 5 SiO 14 , LGS) and catangasite (Ca 3 TaGa 3 Si 2 O 14 , CTGS) are reviewed with respect to their impact on electrical conductivity and acoustic loss. The focus on these crystals also enables a comparison of electroacoustic properties of partially disordered (LGS) and ordered (CTGS) crystals and the formulation of approaches for reducing acoustic loss and enhancing device performance. Starting with defect chemistry models for LGS and CTGS, electrical conductivities as a function of temperature and oxygen partial pressure are considered. One result of this analysis is that contributions of oxygen ions to the total conductivity are determined to be relatively small in the studied crystals. Temperature-dependent acoustic loss of LGS and CTGS crystals is also studied. Two independent techniques, contact resonant piezoelectric spectroscopy, and a contactless tone-burst excitation technique, are applied. Contributions to the measured acoustic loss are determined by fitting loss-related functions for point defects and conductivity-related relaxations. The extracted fit parameters, in particular the activation energies of the processes, are discussed and compared with that of the electrical conductivity. The losses are caused by a superposition of several mechanisms including conductivity-related relaxations, point-defect relaxations and intrinsic phonon-phonon loss. The long-term stability of the crystals is also evaluated at 1000 °C with respect to fundamental materials properties including electrical conductivity and resonant frequency. After one year of thermal treatment, the resonance frequency of CTGS resonators from different crystal sources is found to decrease by no more than 0.4 %. Thus, the applicability of CTGS as a piezoelectric resonator that operates for long periods at extreme temperatures, such as a resonant nanobalance, is demonstrated. Application examples to be presented include resonant nanobalances for in-situ monitoring of non-stoichiometry and phase transformations in thin films during growth at high temperatures. In this context, the key application properties of the sensors at high temperatures, such as mass sensitivity and resolution, are discussed. As an application example, the attached figure shows the oxygen non-stoichiometry x of thin praseodymium-cerium oxide films (Pr 0.1 Ce 0.9 O 2-x ) at 700 °C as a function of oxygen partial pressure determined by LGS and CTGS nanobalances, which agrees very well with literature data (chemical capacitance: D. Chen et al., Chem. Mater. 2014, 26, 22, 6622–6627). Figure 1

Temperature Characteristics of Langasite Surface Acoustic Wave Resonators Coated with SiO2 Films

Effect of Temperature on the Emission Properties of Quasi 2D Glass-Like Carbon Placed on Silicon and Silicon Dioxide Substrates

Design and Performance Analysis of a High-temperature Sensor with a Low-temperature Coefficient of Frequency

Comparative Study of SAW Temperature Sensor Based on Different Piezoelectric Materials and Crystal Cuts for Passive Wireless Measurement

Surface Acoustic Wave Devices Based on High Quality Temperature-Compensated Substrates

Temperature-Compensated High-Frequency Surface Acoustic Wave Device

Langasite-based SAW high-temperature vibration sensor with temperature decoupling

Langasite as Piezoelectric Substrate for Sensors in Harsh Environments: Investigation of Surface Degradation under High-Temperature Air Atmosphere

Temperature characteristics of surface acoustic wave resonators prepared on (0°, 90°, ψ) CTGS cuts

Investigation on the temperature coefficient of frequency performance of LiNbO3 on quartz and glass surface acoustic wave resonators

High Temperature Effects on Surface Acoustic Wave Strain Sensor

Simulation Design of Surface Acoustic Wave Sensor Based on Langasite Coplanar Integration with Multiple Parameters

A langasite surface acoustic wave wide-range temperature sensor with excellent linearity and high sensitivity

Novel Surface Acoustic Wave Strain Sensor with Enhanced High-Temperature Performance and Resistance to Aging

Geometry Characteristics and Wide Temperature Behavior of Silicon-Based GaN Surface Acoustic Wave Resonators with Ultrahigh Quality Factor

High-resolution, high-linearity temperature sensor using surface acoustic wave device based on LiNbO3/SiO2/Si substrate

High-Temperature Piezoelectric Resonators: Electroacoustic Properties and Applications of Langasite-Type Crystals

Surface Acoustic Wave Bound State in the Continuum for 1200°C High Temperature Sensing

Temperature Characteristic of Ring Resonator in Polarization Maintaining Silica Optical Waveguide

Novel Multilayer SAW Temperature Sensor for Ultra-High Temperature Environments