Abstract:Charge accumulation usually happens on the surface of spacers under DC operation, which is susceptible to inducing surface flashover. In order to explore the surface charge accumulation mechanisms and the influences of dielectric conductivity, gas ion mobility, and temperature field on the surface charges, a time-varying charge density model at the gas–solid interface of spacers was established. The results of the simulation show that the discontinuity of the current density between the spacer bulk side and the gas ion flow is the fundamental reason for the charge accumulation on the spacer surface. Additionally, the value of current density fluxes at the interface continues to decrease with the change of the electric field, and the progress of charge transfer gradually stabilizes. Moreover, the dielectric conductivity directly affects the charge accumulation process, and there is a critical conductivity in which the effect of charge conduction in dielectrics counteracts that of gas-phase charge deposition, theoretically. When the conductivity is higher than the critical conductivity, the solid-side charge conduction is the main source of the surface charge accumulation, while the gas-phase charge deposition on the gas side plays a dominant role when the conductivity is lower than the critical conductivity. The charge accumulation is not significantly affected by gas ion mobility when the temperature is evenly distributed. However, under the temperature field with gradient distribution, the current density fluxes at the interface change, causing the polarity reverse of the accumulated charge. In the high-temperature region, the volume current density surges simultaneously with the conductivity, leading to a higher density of surface charge accumulation. Lastly, the design of spacers needs to keep the current densities on both sides of the interface as similar as possible in order to avoid excessive charge gathering in localized areas.

Surface Charge Tailoring Strategy Using SiC Doped Bowl Shaped Spacer

Surface Charge Tailoring Strategy Based On Temperature Field Regulation

Novel HVDC Spacers by Adaptively Controlling Surface Charges – Part Iii: Industrialization Prospects

Surface Charging Phenomena on HVDC Spacers for Compressed SF 6 Insulation and Charge Tailoring Strategies

Designing HVDC GIS/GIL spacer to suppress charge accumulation

Thermal Gradient Effects on Surface Charge of HVDC Spacer in Gas Insulated System

Surface Charge Inversion Algorithm Based on Bilateral Surface Potential Measurements of Cone-Type Spacer

Field-dependent Charging Phenomenon of HVDC Spacers Based on Dominant Charge Behaviors

Electric Field Relaxation of HVDC GIL Spacer with Surface Conductivity Gradient Material (σ-SFGM) Using Electrospinning Technology

Novel HVDC Spacers by Adaptively Controlling Surface Charges – Part Ii: Experiment

Charge Accumulation Patterns on Spacer Surface in HVDC Gas-Insulated System: Dominant Uniform Charging and Random Charge Speckles

Review and Prospect of Surface ChargeInversion Algorithm of Cone-Type Spacer Based on Surface Potential Measurements

Metal Particle Induced Spacer Surface Charging Phenomena in Direct Current Gas-Insulated Transmission Lines

Surface Charging Affecting Metal Particle Lifting Behaviors Around Epoxy Spacer of HVDC GIL/GIS

Optimization of Carbon Nanotube Doping on Nonlinear Conductivity, Surface Charge Dissipation and Electric Field Regulation of SiC/SR Composites Insulators Subjected to DC High Voltages

Surface Charging Characteristics of GIL Model Spacers under DC Stress in C4F7N/CO2 Gas Mixture

Measurement Method and Accumulation Characteristics of Surface Charge Distribution on Polymeric Material under DC Voltage

Electric-field-induced assists fabrication of micro-SiC/Epoxy coating with low additive amount to improve surface insulating performance of HVDC insulator

Gas–solid Interface Charge Characterisation Techniques for HVDC GIS/GIL Insulators

Characteristics of Surface Charge Accumulation on Spacers and Its Influencing Factors

Significantly suppressing metal particle-induced surface charge accumulation of spacers in DC gas-insulated power transmission lines