Abstract:Abstract Clay is a vital industrial raw material, and its physical and mechanical properties undergo significant changes when heated at high temperatures. A good understanding of those properties can provide details on the best use of clay, and may eventually facilitate new application areas. In this paper, the physical and mechanical properties of clay after exposure to high temperatures at two different oxygen levels and cooled in two different ways are studied. In the experiment, the clay samples are heated at high temperatures in anoxic conditions and air. The anoxic conditions are facilitated by a closed crucible. After the sample reaches the target temperature (400°C, 500°C, 600°C, 700°C, 800°C and 900°C), it is cooled to room temperature slowly in the furnace. The samples that are heated in air are either cooled in the furnace or quenched in water. Finally, the appearance of the clay samples in terms of their surface color and development of cracks, as well as their shrinkage, mass loss, hardness, strength and deformation, and the color of the core are examined and measured. The results show that the color of the surface of the clay samples heated in anoxic conditions and air significantly differs, and the color of the core is grayish black at temperatures that are below 800°C, which is possibly related to the oxidation and reduction of iron ions. Cracks in the clay samples partially offset shrinkage. The clay samples quenched in water show larger cracks and lower compressive strength. The mass of the samples does not change at temperatures that exceed 800°C. The hardness also does not change at temperatures that are higher than 700°C. In summary, temperatures between 700°C and 800°C have the most impact on clay because many of the physical properties (including their surface color and color of the core, shrinkage, mass, hardness, and strength) vary greatly at this temperature range.

Effects of High Temperature Treatment on Physical-Thermal Properties of Clay

Effects of high temperature thermal treatment on the physical properties of clay

Variations of Strength, Resistivity and Thermal Parameters of Clay after High Temperature Treatment

Experimental Study on Thermophysical Properties of Clay after High Temperature

Physical and Mechanical Properties of Clay After Heating in Different Oxygen Levels and Cooling With Different Methods

Investigating Temperature Effects on the Shear Behavior of Clays: Molecular Dynamics Simulations

Thermal Damage on Claystone After Exposure to Different High Temperatures: A Review

The thermodynamic properties variation of cemented clay after treatment at high temperatures

Experimental study on physical properties of Shanghai soft clay under high temperatures

Correlation analyses of effects of temperature on physical and mechanical properties of clay

Experimental Study on Physical Properties of Soft Soil after High Temperature Exposure

Thermal properties of sandstone after treatment at high temperature

Experimental Investigation on Heat Transfer Characteristics of Soft Clay at High Temperatures

Effect of high temperature on physical properties of yellow sandstone

The impact of high temperature on mechanical properties and behaviors of sandstone

The plastic behavior and compression of bentonite clay under heating effect

Experimental study on temperature effect on engineering properties of clayey soils

Sintering effects on the development of mechanical properties of fired clay ceramics

Experimental study on the variation of physical and mechanical of rock after high temperature treatment

The effects of high temperature heating on the gas permeability and porosity of a cementitious material

Variation of wave velocity and thermal conductivity of concrete after high-temperature treatment