Abstract:As a major steel producer, China is now eager to develop feasible solutions to recycle and reuse steel slag. However, due to the relatively poor hydration activity of steel slag, the quantity of steel slag used as a supplemental binder material is limited. In order to improve the cementitious properties of steel slag, the strength and carbonation degree of the high-content steel slag powder–cement–metakaolin composite cementitious material system under CO2 curing conditions were investigated. The compressive strengths of the mortar specimens were tested and compared. The carbonation areas were identified and evaluated. A microscopic analysis was conducted using X-ray diffraction (XRD), thermogravimetry analysis (TG), and scanning electron microscopy (SEM) to reveal the chemical mechanisms. The results showed that CO2 curing significantly increased the early strength as the 3D compressive strength of the specimens increased by 47.2% after CO2 curing. The strength of the specimens increased with increasing amounts of metakaolin in a low water-to-binder ratio mixture. The 3D compressive strength of the specimens prepared with 15% metakaolin at a 0.2 water-to-binder ratio achieved 44.2 MPa after CO2 curing. Increasing the water-to-binder ratio from 0.2 to 0.5 and the metakaolin incorporation from 0% to 15% resulted in a 25.33% and 19.9% increase in the carbonation area, respectively. The calcium carbonate crystals that formed during carbonation filled the pores and reduced the porosity, thereby enhancing the strength of the mortar specimens. The soundness of the specimens after CO2 curing was qualified. The results obtained in the present study provide new insight for the improvement of the hydration reactivity and cementitious properties of steel slag powder.

Upcycling Carbon Dioxide to Improve Mechanical Strength of Portland Cement

Sustainable Building Material from CO2 Mineralization Slag: Aggregate for Concretes and Effect of CO2 Curing

Enhanced Carbonation Curing of Cement Pastes with Dolomite Additive

Mechanism Underlying Early Hydration Kinetics of Carbonated Recycled Concrete Fines-Ordinary Portland Cement (CRCF-OPC) Paste

Microstructure Refinement of Calcium-Sulfate-aluminate and Portland Cement (CSA-PC) Hybrids with Accelerated CO2 Curing (ACC)

Carbonation Curing of Industrial Solid Waste‐based Aerated Concretes

Carbon dioxide as an admixture for better performance of OPC-based concrete

Conversion of [math] and Its Utilization in the Preparation of Cement-Slag-[math] Ternary Blends

Influences of titanium dioxide nanoparticles on regulation of crystalline growth and early carbonation of cementitious composites

CO2 Sequestration in the Production of Portland Cement Mortars with Calcium Carbonate Additions

An Overview on the Influence of Various Parameters on the Fabrication and Engineering Properties of CO2-cured Cement-Based Composites

Effect of Carbonation Treatment on the Strength and CO2 Uptake Rate of Composite Cementitious Material with a High Steel Slag Powder Content

Synthesis of nano-calcium carbonate from waste cement and techno-economic and environmental evaluation

Recycling of calcined carbonated cement pastes as cementitious materials: Proposed CCUS technology for calcium looping

Mechanical and microstructural performances of fly ash blended cement pastes with mixing CO2 during fresh stage

Effect of CO2-mixing dose and prolonged mixing time on fresh and hardened properties of cement pastes

Experimental study on the macroscopic and microscopic properties of cement paste backfill after treatment with carbon dioxide carbonize filling slurries during the mixing process

Accelerated Mineral Carbonation Curing of Cement Paste for CO2 Sequestration and Enhanced Properties of Blended Calcium Silicate

Enhancing performance and sustainability of ultra-high-performance concrete through solid calcium carbonate precipitation

Investigations on factors influencing physical properties of recycled cement and the related carbon emissions and energy consumptions

Synergizing Portland Cement, high-volume fly ash and calcined calcium carbonate in producing self-compacting concrete: A comprehensive investigation of rheological, mechanical, and microstructural properties