Abstract:Nonlinear drag force has been a research frontier in complex gas-solid systems. The literature has reported that the commonly-used drag correlations often overestimate drag force and, thus, cause unrealistic homogeneous flow structures in gas-solid fluidized beds of fine particles. For solving this problem, the structure-dependent drag model, derived from energy-minimization multi-scale approach, is used in discrete simulations of fluid catalytic cracking particles in a small riser. The gas phase is dealt with by computational fluid dynamics. Particles are considered as a discrete phase and described by Newton’s second law of motion. Gas-particle phases are coupled according to Newton’s third law of motion. Simulations show that use of structure-dependent drag model results in drag reduction, the effect of which is not so apparent as that in simulations of the two fluid model. The particle clustering tendency, however, is more distinct and leads to more heterogeneous flow structures in riser flow with a much greater amplitude of outlet solid flux fluctuations. Moreover, the behaviors of particle and gas back-mixing can be captured in the present simulations, which was supported by past simulations and experimental data. The simulation time resolution is discussed. The spring constant can be artificially brought down for safe setting of larger time step when modelling the collision process between fine particles with a higher calculation load. To appropriately mimic the continuous decay of van der Waals force may, however, need a much smaller time step. There is also an obvious effect of space resolution on simulations. When using a grid size smaller than 3 times the particle diameter, the simulated clusters turn extraordinarily large, and the effect of gas-solid back-mixing turns insignificant.

Modeling And Simulation Of Particle Dispersion In Dense Particle-Laden Flow

Modelling of heavy and buoyant particle dispersion in a two-dimensional turbulent mixing layer

Models of Interphase Drag Force from Direct Numerical Simulations of Upward Turbulent Particle-Laden Channel Flows

Dispersion of cylindrical particles in turbulent flows

Numerical Simulation of the Accumulation of Heavy Particles in a Circular Bounded Vortex Flow

Drag Model from Interface-Resolved Simulations of Particle Sedimentation in a Periodic Domain and Vertical Turbulent Channel Flows

Investigation on ultralight particle dispersions in dense two-phase flow using a kinetic friction stress model

A Euler-Euler Hydrodynamic Modelling and Simulation of Dense Particle Flow in a Small-Scale Fluidized Bed

Drag Force Model Corrections Based on Nonuniform Particle Distributions in Multi-Particle Systems

Experiment and Simulation Using Diffusion Flux Model for Gas-Particle Two-Phase Flow in a Suspension Bed

Hydrodynamic Modeling of Turbulence Modulation by Particles in a Swirling Gas–Particle Two-Phase Flow

Test Of A Generalized Drift Flux Model For Simulating Indoor Particle Dispersion

DPM Simulations of A-Type FCC Particles’ Fast Fluidization by Use of Structure-Dependent Nonlinear Drag Force

Drag Force in Dense Gas-Particle Two-Phase Flow

Hydrodynamic Modeling of Turbulence Modulation by Particles in Swirling Gas-Particle Two-Phase Flow

Effects of Momentum Transfer on Particle Dispersions of Dense Gas–particle Two-Phase Turbulent Flows

Hydrodynamic modeling of coaxial confined particle-laden turbulent flow

Modeling total drag force exerted on particles in dense swarm from experimental measurements using an inline image-based method

Particle-resolved simulation of freely evolving particle suspensions: Flow physics and modeling

Effect of Drag Force on Backward-Facing Step Gas-Particle Turbulent Flows

A modified drift coefficient model and its application