Abstract:A MoNx coating serves as an effective wear protection layer and is crucial for the investigation of its tribological characteristics at various temperatures. This study examined the tribological characteristics of MoNx coatings that were deposited through high-power pulsed magnetron sputtering (HiPIMS) in an Ar/N2 environment with varying N2 partial pressures. The microstructures and mechanical properties of the coatings were elucidated using scanning electron microscopy, grazing-incidence-angle X-ray diffraction, energy-dispersive spectroscopy, and nanoindentation. The dry friction performances of the coatings at different heating temperatures were studied using a ball-on-disk tribometer. The MoNx coating produced by HiPIMS was composed primarily of fcc−Mo2N and featured a fine, dense column crystal with a maximum hardness of 28.8 GPa. The MoNx coatings exhibited excellent lubrication and wear reduction properties at room temperature (RT). The dry friction performances of the MoNx coatings at elevated temperatures were expected to depend on the growth of the MoO3 tribolayer. At relatively low temperatures (300 °C and 400 °C), the MoO3 tribolayer grew slowly and was not enough to provide good lubrication, causing increases in the dry friction of the coatings. However, the δ−MoN phase formed in the MoNx coating deposited at a high N2 partial pressure could facilitate the formation of MoO3 and thus decreased the friction coefficient at 400 °C. At the relatively high heating temperature of 500 °C, however, the MoO3 tribolayer grew so rapidly that the oxide layer became thick, resulting in an increase in the wear rate. It is believed that tuning the growth rate of MoO3 via optimizing the composition and structure of the MoNx coatings might be a useful way to improve the dry friction at various elevated temperatures.

Investigating Tribological Performances for GNPs/MoS 2 Coating at Variable Temperatures

Effect of nano-particles ZnO and layered GO on high temperature tribological performance of MoS2-based heterojunction composite lubricating coating

Preparation and tribological properties of multi-layer graphene/silicon dioxide composites-based solid lubricant coatings at elevated temperatures

Tribological properties of Al-GNP composites at elevated temperature

Effect of Graphene Nanoplatelet Content on Mechanical and Elevated-Temperature Tribological Performance of Self-Lubricating ZE10 Magnesium Alloy Nanocomposites

Dry Friction Performances of MoNx Coatings Deposited by High−Power Pulsed Magnetron Sputtering

Magnesium Silicate Hydroxide–MoS2–Sb2O3 Coating Nanomaterials for High-Temperature Superlubricity

Performance of MoS2/Zr Composite Coatings at Different Deposition Temperatures

High Temperature Tribological Properties of Nano La2O3-Doped MoSi2 Composite Coatings Sintered in Vacuum

High Temperature Superlubricity Behaviors Achieved by AlSiN Coatings Against WS2 Coatings at 600 °C

Tribological performance of Mn3(PO4)2 coating and PC/MoS2 coating in Rolling–Sliding and pure sliding contacts with gear oil

Tribological behaviors of nano-schistose MSH in phosphate/graphite composite lubricating coatings under different friction temperatures

High temperature tribological behaviors and wear mechanisms of NiAl-MoO3/CuO composite coatings

Tribological properties of molybdenum ion-plated and ion-sulfurized composite coating on mild steel

Effect of Temperature on the Friction and Wear Behavior of Electroless Ni–P–MoS2–CaF2 Self-Lubricating Composite Coatings

Investigation of the elevated temperature tribological property and wear mechanism of Fe‐15Cu‐0.8C materials containing Mo‐coated MoS2 powders

High temperature tribological performance of nickel-based composite coatings by incorporating multiple oxides (TiO2–ZnO–MoO3)

Tribological Properties of Adaptive Ni-Based Composites with Addition of Lubricious Ag 2 MoO 4 at Elevated Temperatures

Study on Atmospheric Tribology Performance of MoS2–W Films with Self-Adaption to Temperature

High-Temperature Friction and Wear Behavior of Nickel-Alloy Matrix Composites with the Addition of Molybdate

Effect of Nano-ZrO2 on the Microstructure and High Temperature Tribological Properties of MoSi2 Coating