Abstract:In this paper, an experimental investigation of flow boiling in a horizontal narrow microchannel with hydraulic diameter of D-h = 952 mu m was conducted. Flow boiling heat transfer characteristics of micropin-finned surfaces were evaluated over the mass fluxes range from 200 - 500 kg/m(2)s (corresponding flow velocity: 0.2 - 0.5 m/s), using deionized water as the working fluid with different inlet temperatures T in = 30 - 50 degrees C. The outlet pressure of the microchannel was about 1 atm. The boiling curves, heat transfer coefficients, bubble behaviors and heat transfer enhancement mechanism were discussed with the variation of heat flux, mass flux and inlet temperature. The results indicated that the micro-pinfinned surfaces could improve the critical heat flux (CHF) and heat transfer coefficient (HTC) greatly due to numerous nucleate sites and large heat transfer area enhancement ratio. The CHF up to 360 W/cm2 has been demonstrated at a mass flux of 500 kg/m(2)s. Compared with a smooth surface, a 240% higher heat transfer coefficient (18.4 W/cm(2)K) on the S30-120 surface has been achieved at a mass flux of 500 kg/m(2)s with an inlet temperature of 30 degrees C. The boiling curves of the micro-pin-finned surfaces presented an obvious "hook back" phenomenon after reaching the onset of the nucleate boiling (ONB) and then the wall temperature had a slight rise with the increase of the heat flux. Moreover, the intensive micropin-finned arrangements showed a significant wicking effect and promoted liquid replenishment, which could destroy the liquid boundary and enhance turbulence. The bubble behaviors were also captured to explain the heat transfer enhancement mechanism in a horizontal narrow microchannel. (C) 2022 Elsevier Ltd. All rights reserved.

Heat transfer correlations for jet impingement boiling over micro-pin-finned surface

Enhanced Heat Transfer Characteristic of Micro-Pin-Finned Surfaces With Jet Impingement

Confined Submerged Jet Impingement Boiling of Subcooled Fc-72 over Micro-Pin-Finned Surfaces

On heat transfer and flow characteristics of jets impingement on a concave surface with varying pin-fin arrangements

Boiling heat transfer characteristics of pin-finned surface in distributed jet array impingement

Flow and Heat Transfer Characteristics of Micro Pin-Fins under Jet Impingement Arrays

Numerical Investigation of Impingement Heat Transfer on A Flat and Square Pin-Fin Roughened Plates

An Experimental Investigation Of Impingement Heat Transfer In Narrow Space With Full-Height Pin Fins

Numerical predictions of jet impingement heat transfer on square pin-fin roughened plates

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

Experimental Investigation of Local and Average Heat Transfer Coefficients under an Inline Impinging Jet Array, Including Jets with Low Impingement Distance and Inclined Angle

Enhanced Flow Boiling Heat Transfer with Jet Impingement on Micro-Pin-finned Surfaces

Convective heat transfer of microchannel heat sinks with pinfins and jets for a heat flux up to 500 W/cm 2

Experimental and Numerical Study on Heat Transfer with Impinging Circular Jet on a Convex Hemispherical Surface

Influences of Micro Pin-Fin on Jet Array Impingement Heat Transfer: Effects of Jet to Target Distance, Micro Pin-Fin Shapes, Height, and Reynolds Number

Jet impingement heat transfer performance in a double-wall cooling structure with film effusion holes and pin fins

Flow Boiling Heat Transfer Characteristics on Micro-Pin-finned Surfaces in a Horizontal Narrow Microchannel

Experimental Study of Saturated Flow Boiling Heat Transfer in an Array of Micro-pin-fins

Numerical Study On Flow And Heat Transfer Characteristics Of Jet Impingement

Investigation on Flow Characteristics and Its Effect on Heat Transfer Enhancement in a Wide Channel With Staggered Diamond-S Pin Fins

Jet Impingement Heat Transfer in Narrow Channels with Different Pin Fin Configurations on Target Surfaces