Abstract:This paper presents the results of the experimental and numerical studies on the influence of drilling damage of wood on the wood embedment behavior. Wood drilling tests were conducted to quantify the distribution of wood residual strain by use of digital image correlation technique. Parallel to wood grain repetitive compression tests were also conducted to determine the mechanical properties of wood within the kinking zone. Wood half-hole bolt embedment tests were conducted, and a wood kinking layer model was proposed and incorporated into a FEM model for the wood embedment behavior simulation. The model predictions were compared with the embedment test results and results from FEM models with different consideration of the weakened wood around the bolt holes. It was found that drilling can develop significant parallel and perpendicular to grain and shear residual strain in the surrounding wood. The distribution and magnitude of the residual strains were correlated with the hole diameter and drilling speed, and the thickness of a kinking layer can be taken as 1/13 and 1/7 of the hole diameter under the low and high drilling speeds considered in this study, respectively. It was observed from the repetitive tests of wood that during the steady-state kinking process, wood exhibited nearly constant peak stress and reloading modulus of elasticity. The FEM model with the proposed kinking layer model achieved a better agreement with the test results than FEM models based on wood foundation theory or a nonlinear contact model regarding the embedment elastic modulus, the maximum load, and the distribution of the strain in the embedment zone.

Three-Dimensional Combined Elastic-Plastic and Damage Model for Nonlinear Analysis of Wood

Failure Analysis of Notched Composite Laminate with 3D Continuum Damage Mechanics

Nonlinear three-dimensional anisotropic material model for failure analysis of timber

Damage Analysis of Composite Laminate with Large Open-hole under Compression Using 3D Strain Progressive Damage Theory

3D orthotropic damage model for the failure analysis of LVL wood truss with steel connector through a regularized extended finite element method

A novel constitutive model for the porosity related super-large deformation and anisotropic behavior of wood under perpendicular to grain compression

Finite Element Analysis of a Modified Progressive Damage Model for Composite Laminates under Low-Velocity Impact

A Coupled Elastic-Plastic Damage Model for the Mechanical Behavior of Three-Dimensional (3D) Braided Composites

THE ANALYTICAL SOLUTION OF A MORPHOLOGY-BASED MODEL USED TO EVALUATE THE INFLUENCE OF DAMAGE FOR WOOD STRUCTURES

Three-dimensional numerical analyses of load-bearing behavior and failure of multiple double-shear dowel-type connections in timber engineering

A multiscale elasto-plastic damage model for the nonlinear behavior of 3D braided composites

A 3D objective material model for elastic-plastic damage behavior of fiber reinforced polymer composites

A 3D Non-Orthogonal Plastic Damage Model for Concrete

An elastic-plastic kinking layer model for parallel-to-grain wood embedment behavior considering wood drilling damage

A constitutive model considering creep damage of wood

A Micromechanics Based Elasto-Plastic Damage Model for Unidirectional Composites under Off-Axis Tensile Loads.

Parameter-based Applicability Analysis of Gerhards Cumulative Damage Model in Residual Strength and Life Prediction of Wood in Bending

A Two-Dimensional Lattice Model for Simulating the Failure and Fracture Behavior of Wood

Rheological Model for Wood

A Plasticity-based Damage Model for Concrete

A Elastic Plastic Viscous-Damage Model For Concrete Considering Strain Rate Effect And Application