Abstract:Although several technologies, such as reactive distillation and catalytic membrane reactor, have been proposed to improve HI conversion efficiency, they still experience several challenges for the application in HI section. In this study, an electrochemical cell was employed for hydriodic acid decomposition under the presence of iodine. Several commercial proton-exchange membranes (PEMs), namely, Nafion 117 and Nafion 115, were used as separators for the electrochemical cell. Anodization of iodide anion occurred at the graphite electrode in the anode compartment. Hydrogen was generated by the reduction reaction of hydrogen cations, which migrated from anolyte to catholyte. In electrolysis experiments, PEM showed good performance in terms of high transport number of proton and low iodine permeation. Several parameters, such as operating temperature, HI molarity, and 12 molarity in anolyte, which affected current efficiency, iodine permeance, and electric resistance of test cell, were investigated. High operating temperature and I-2 molarity in anolyte enhanced the permeability of iodine, which had several negative influences on electrochemical cell performance. Although current efficiency was negatively affected by increasing temperature and I-2 molarity, it still remained above 0.85 in the range of 30 degrees C-75 degrees C. Ohmic resistance, which is a component of cell resistance, offered by PEM was investigated with Nafion 117 and 115. Apart from graphite plates, activated carbon papers were adopted as electrodes to reduce the overpotentials due to their high specific surface characteristic. (C) 2018 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Effect of Iodine Precipitation on HI Separation Subsection in Sulfur-Iodine Cycle for Hydrogen Production

Experimental Study on the Purification of HIx Phase in the Iodine–sulfur Thermochemical Hydrogen Production Process

Concentration of HI in Iodine–Sulfur Cycle Using EED Stack

Experimental Study of the Characteristics of HI Distillation in the Thermochemical Iodine–Sulfur Cycle for Hydrogen Production

Progress of HI concentration/separation in the iodine-sulfur thermochemical cycle for hydrogen production

HI Concentration of HIx (HI-H2O-I2) Solution in Iodine-Sulfur Water-Splitting Cycle by Electro-Electrodialysis

HIx Concentration by Electro-Electrodialysis Using Stacked Cells for Thermochemical Water-Splitting IS Process

Decomposition of Hydriodic Acid by Electrolysis in the Thermochemical Water Sulfur–iodine Splitting Cycle

Comparison of Various Circuit Designs in the HI Decomposition Section of the Iodine–sulfur Process

Modeling and Validation of the Iodine‐sulfur Hydrogen Production Process

Effects of the Operation Modes on the HIx Phase Purification in the Iodine–sulfur Thermochemical Cycle for Hydrogen Production

Study on the phase separation characteristics of HI–I 2 –H 2 SO 4 –H 2 O mixture at 20°C

Optimization of liquid–liquid phase separation characteristics in the Bunsen section of the sulfur–iodine hydrogen production process

Simulation Study about the Effect of Pressure on Purification of H2SO4 and HIx Phases in the Iodine–sulfur Hydrogen Production Cycle

Purification of Sulfuric and Hydriodic Acids Phases in the Iodine-sulfur Process

Evaluation on the Electro-Electrodialysis Stacks for Hydrogen Iodide Concentrating in Iodine–sulphur Cycle

A Totally Heat-Integrated Distillation Column (thidic) – the Effect of Feed Pre-Heating by Distillate

SIMULATION OF HYDROGEN PRODUCTION BY SULFUR-IODINE THERMO-CHEMICAL CYCLE PROCESS

Experimental investigation on two-phase separation\characteristics of Bunsen reaction in sulfur-iodine cycle for hydrogen production

Phase Separation Characteristics of HI–I2–H2SO4–H2O Mixture at Elevated Temperatures

Review of Thermodynamic Properties of the Components in HI Decomposition Section of the Iodine–sulfur Process