Abstract:An oxalic acid (H2C2O4) and hydrogen peroxide (H2O2) leaching–chemical precipitation process was developed to recover valuable metals from the spent acrylonitrile catalysts that primarily contain Mo, Ni, Fe and Bi. H2C2O4 and H2O2 leaching studies indicated good leaching efficiencies for Mo and very low efficiencies for Ni because of the formation of soluble molybdenum oxalate complexes and a nickel oxalate (NiC2O4) precipitate, which was separated by filtration. Under the optimal leaching conditions (H2C2O4 concentration of 1.25mol/L, H2O2 concentration of 0.20mol/L, leaching temperature of 50°C, liquid-to-solid (L/S) ratio of 20mL/g and leaching time of 2.5h), 99.7% of Mo was dissolved into the liquid phase, and 98.4% of Ni remained in the residues. For purification, the molybdenum oxalate complexes in the leaching liquor were broken down by adding the emulsion of Ca(OH)2 to form calcium molybdate (CaMoO4) and calcium oxalate (CaC2O4) precipitates; molybdenum trioxide (MoO3) was then recycled, followed by processes of acid dissolution, ammonium molybdate deposition, and calcining. The NiC2O4 in the leaching residues was dissolved and converted into soluble nickel-oxalate-ammonium complexes by adding ammonium hydroxide (NH4OH), and pure NiC2O4 powders were obtained from the filtered liquor through an ammonia stilling process after filtration. In this case, 95% of the Mo and 97% of the Ni in the spent catalyst were recovered as MoO3 and NiC2O4 with purities of 97.88% and 99.91%, respectively. Based on the results of the present study, a tentative process flow sheet is proposed.

Recovery of Nano-TiO 2 from Spent SCR Catalyst by Sulfuric Acid Dissolution and Direct Precipitation

Reconstruction and recovery of anatase TiO 2 from spent selective catalytic reduction catalyst by NaOH hydrothermal method

Iron removal and titanium dioxide support recovery from spent V2O5-WO3/TiO2 catalyst

Environmentally-friendly Harvesting TiO2 Nanospheres and V2O5 Microrods from Spent Selective Catalytic Reduction Catalysts

Comprehensive recovery of W, V, and Ti from spent selective reduction catalysts

Preparation of Adsorptive TiO2/SiO2 Core-Shell Nanospheres by Ultrasonic-Coupled Alkali Leaching Process: Synergy of Adsorption and Photocatalysis Towards 2,4-Dinitrophenol Removal

Preparation of adsorptive TiO 2 /SiO 2 core-shell nanospheres by ultrasonic-coupled alkali leaching process: Synergy of adsorption and photocatalysis towards 2,4-dinitrophenol removal

g-C3N4 doping TiO2 recovered from spent catalyst for H2 evolution from water

A Facile Route for Spraying Preparation of Pt/TiO2 Monolithic Catalysts Toward VOCs Combustion

Simple preparation of nano-anatase titanium dioxide from cold rolled titanic acid waste liquid

RAPID SYNTHESIS OF NANO-TITANIUM DIOXIDE BY COMBUSTION METHOD AND ITS PHOTO-CATALYSIS PERFORMANCE

Thermocatalytic Conversion of Automotive Shredder Waste and Formation of Nanocarbons As a Process Byproduct

TiO2 Recovered from Spent Selective Catalytic Reduction Catalysts As Anode Material for Lithium-Ion Batteries

Nanoization Characteristics and Photocatalytic Degradation Performance of Deactivated SCR Catalysts Containing TiO2

Recovery of Mo and Ni from spent acrylonitrile catalysts using an oxidation leaching–chemical precipitation technique

Recovery of titania from high titanium slag by roasting method using concentrated sulfuric acid

Preparation of Fly Ash Based Titanium Dioxide Composite Photocatalysts Using Spent SCR Catalyst Carriers

Simultaneous removal of Cr(III) and V(V) and enhanced synthesis of high-grade rutile TiO2 based on sodium carbonate decomposition

A novel preparation of titanium dioxide from titanium slag

Nanoization characteristics and photocatalytic degradation performance of deactivated SCR catalysts containing TiO 2

Preparation of TiO2 Composite Photocatalyst Using Amorphous SiO2 Microspheres Loaded with Spent SCR Catalysts