Abstract:Lauric acid (LA) shows much potential as one organic phase change material (PCM) for thermal energy storage, owing to its suitable melting point, relatively high thermal/chemical stability and latent heat. However, the LA-based thermal storage method invariably suffers from the big challenges of liquid leakage tendency and low thermal conductivity of single lauric acid, limiting immensely its practicality. Herein, one encapsulation and modifying strategy to fabricate high conductive and low liquid leakage composite phase change materials (CPCMs) for photo-thermal storage was proposed by constructing novel graphene doped LA/g-C3N4 CPCM. Firstly, LA is infiltrated into a novel two-dimensional porous matrix – the graphitic phase carbon nitride (g-C3N4) to prevent liquid leakage in the solid-liquid phase change process. Then it is further incorporated with a certain amount of graphite nanoplatelets to further enhance thermal conductivity. The encapsulation and modifying strategy enable the graphene doped LA/g-C3N4 to show excellent thermal storage performance for both heat and light energy, low liquid leakage, and high thermal stability. The hybrid LA/g-C3N4 with 5 wt% graphene (CPCM3) modification has a melting temperature of 45.88 °C and enthalpy of 159.19 J/g. The corresponding solidification temperature and enthalpy are 43.36 °C and 144.40 J/g, respectively. Its thermal conductivity at 50 °C is enhanced to 0.9338 W/(m·K) (one time higher than single LA), also superior to the state-of-the-art LA-based CPCMs. After 100 thermal cycles, the composite phase change material only suffers low mass loss and latent heat loss of phase change, which proves the good thermal reliability. Furthermore, TGA and DTG data indicate that CPCM3 can maintain good thermal stability in the normal operating temperature range. In the whole, the joint effect of the porous g-C3N4 matrix and graphene modification improve the thermal storage performance of LA through the improvement of liquid immobilization and thermal conductivity. This work provides a promising strategy for fabricating high conductive and low liquid-leakage CPCM toward enhanced photo-thermal storage.

Fabrication of Shape-Stable Composite Phase Change Materials Based on Lauric Acid and Graphene/graphene Oxide Complex Aerogels for Enhancement of Thermal Energy Storage and Electrical Conduction

Investigation on thermal energy storage characteristics of form-stable phase change materials supported by graphene aerogel

Form-stable phase change material embedded with chitosan-derived carbon aerogel

Enhanced Thermal Performance of Composite Phase Change Materials Based on Hybrid Graphene Aerogels for Thermal Energy Storage

Thermal Behavior and Shape-Stabilization of Fatty Acid Eutectics/electrospun Carbon Nano-Felts Composite Phase Change Materials Enhanced by Reduced Graphene Oxide

Highly thermally conductive phase change composites with excellent solar-thermal conversion efficiency and satisfactory shape stability on the basis of high-quality graphene-based aerogels

Fatty acid eutectics embedded in guar gum/graphene oxide/boron nitride carbon aerogels for highly efficient thermal energy storage and improved photothermal conversion efficiency

Material preparation and heat transfer characterization of porous graphene aerogel composite phase change material

Design of stearic acid/graphene oxide-attapulgite aerogel shape-stabilized phase change materials with excellent thermophysical properties

Graphene aerogel stabilized phase change material for thermal energy storage

Enhanced Thermal Conductive Lauric Acid/G-C3n4/Graphene Composite Phase Change Materials for Efficient Photo-Thermal Storage

Engineering nanocellulose/graphene hybrid aerogel for form-stable composite phase change materials with high phase change enthalpy for energy storage

Synthesis and Thermal Properties of Shape-Stabilized Lauric Acid/Activated Carbon Composites As Phase Change Materials for Thermal Energy Storage

Preparation and Characterization of Lauric–Myristic Acid/Expanded Graphite as Composite Phase Change Energy Storage Material

Shape-stabilized, thermally conductive phase-change composites for thermal energy storage

Silver Attached Graphene-Based Aerogel Composite Phase Change Material and the Enhancement of Thermal Conductivity

Three-Dimensional Macroporous rGO-Aerogel-Based Composite Phase-Change Materials with High Thermal Storage Capacity and Enhanced Thermal Conductivity

Preparation and Thermal Performances of Lauric Acid/Polyvinyl Butyral/Graphene Nanoplates Composite Phase Change Materials

Biomass derived carbon aerogel as an ultrastable skeleton of form-stable phase change materials for efficient thermal energy storage

Carbon hybrid aerogel-based phase change material with reinforced energy storage and electro-thermal conversion performance for battery thermal management

Performance analysis of phase change composites improved with graphene oxide nanoparticle for thermal energy storage