Abstract:In order to improve the performances of phase change material (PCM) in applications, a novel form-stable phase change materials were fabricated via solution blending method in this work. Palmitic acid (PA) was used as phase change material to release and absorb large amounts of latent heat at operating temperature. Polyvinyl butyral (PVB) is the polymer that was used as supporting matrix to prevent the leakage of palmitic acid in melting state. Expanded graphite (EG) was used not only to enhance thermal conductivity of form-stable phase change materials, but also to help reduce leakage. A series of form-stable phase change materials were prepared, containing pure palmitic acid/polyvinyl butyral composites, and palmitic acid/polyvinyl butyral composites doped with expanded graphite of 3 wt%, 5 wt% and 7 wt%. Fourier transformation infrared spectroscope (FT-IR), X-ray diffractometer (XRD), scanning electronic microscope (SEM) and thermal gravimetric analyzer (TGA) were used to analyze the chemical structures, crystal structures, microstructure and thermal stability of the form stable phase change materials. Thermal storage properties were determined by differential scanning calorimeter (DSC), the latent heat value of form-stable phase change material with the highest palmitic acid content (70 wt %) was 128.08 J/g, corresponding to melting point of 59.5 degrees C. The thermal conductivity of form-stable phase change materials which was measured by thermal conductivity meter (TCM) was greatly enhanced by expanded graphite, and the thermal conductivity of form-stable phase change materials can be increased 4.2 times by 7 wt % expanded graphite. Therefore, the novel form-stable phase change materials are promising in thermal energy storage systems, especially in low-temperature solar energy systems.

Form-stable phase change material embedded with chitosan-derived carbon aerogel

Investigation on thermal energy storage characteristics of form-stable phase change materials supported by graphene aerogel

Research on the modification of microencapsulated phase change material for thermal energy storage by nano-SiO2 and graphite

Biomass derived carbon aerogel as an ultrastable skeleton of form-stable phase change materials for efficient thermal energy storage

Graphene aerogel stabilized phase change material for thermal energy storage

A promising form-stable phase change material composed of C/SiO2 aerogel and palmitic acid with large latent heat as short-term thermal insulation

Modified Supporting Materials to Fabricate Form Stable Phase Change Material with High Thermal Energy Storage

A Low-Temperature Phase Change Material Based on Capric-Stearic Acid/Expanded Graphite for Thermal Energy Storage

Lightweight, strong, and form-stable cellulose nanofibrils phase change aerogel with high latent heat

Silica-based aerogels encapsulate organic/inorganic composite phase change materials for building thermal management

Palmitic Acid/polyvinyl Butyral/expanded Graphite Composites As Form-Stable Phase Change Materials for Solar Thermal Energy Storage

Form-stable phase change material embedded in three-dimensional reduced graphene aerogel with large latent heat for thermal energy management

Synthesis and Thermal Properties of 1-Octadecanol/nano-tio2/carbon Nanofiber Composite Phase Change Materials for Thermal Energy Storage

Carbon nanotubes modified graphene hybrid Aerogel-based composite phase change materials for efficient thermal storage

Engineering nanocellulose/graphene hybrid aerogel for form-stable composite phase change materials with high phase change enthalpy for energy storage

Enhanced thermal performance of NaCH3COO·3H2O-Na2S2O3·5H2O eutectic based composite phase change materials with hybrid dimensional carbon nanomaterials and modified lotus root starch

Preparation and properties of CaCl2·6H2O/silica aerogel composite phase change material for building energy conservation

Thermal Performance of Lauric Acid/Bentonite/Carbon Nanofiber Composite Phase-Change Materials for Heat Storage

Fabrication and Performances of New Kind Microencapsulated Phase Change Material Based on Stearic Acid Core and Polycarbonate Shell

Synthesis, Characterization and Properties of Palmitic Acid/high Density Polyethylene/graphene Nanoplatelets Composites As Form-Stable Phase Change Materials

Thermal Properties of Stearic Acid/active Aluminum Oxide/graphene Nanoplates Composite Phase Change Materials for Heat Storage