Abstract:Rollover crashes are complex by their very nature, and have stimulated many researches aimed at improved occupant safety. In order to investigate the vehicle crashworthiness during rollovers, several test modes are generally used to replicate different real world rollover scenarios. However, such tests are very expensive, especially during the development stage of a new car line. Computer modeling is a cost-effective way to study rollover crashes. However, a survey of literature showed that only rigid-body dynamics based models have been used for rollover simulations. It is well known that this class of models cannot be used to simulate component deformation and structural collapses. Finite element (FE) method, which has been widely used to simulate frontal and side crashes, was rarely used for simulating rollover crashes, due mainly to the relative long duration of a rollover crash. The objective of this study was to develop an FE model for investigating vehicle crashworthiness during three commonly used rollover tests. An FE model of an SUV was developed in this study. Several sub-models, namely the vehicle structure sub-model, the tire sub-model, the suspension system sub-model, the restraint system sub-model, and the dummy model were generated and integrated together. The structure model was first used to simulate the roof crush test as prescribed in FMVSS 216. The resulting load versus roof crush curve matched well against test results. The integrated model was then used to simulate three laboratory-based rollover test modes, namely the SAE J2114 dolly test, curb-trip test, and corkscrew test. For each test mode, up to 1.5 seconds of simulation time (about 1 full vehicle roll) were computed. The vehicle kinematics, including the angular velocity, lateral acceleration, and vertical acceleration during these three test modes were computed and compared with experimental data. The simulated dummy head accelerations, timing and location of the most severe impact to the dummy’s head were also compared with the experimental results. Results showed very good agreement between the tests and simulations. In order to reduce the computational time, multiple CPUs were used. Approximately ten hours were required to run a 1.5 second rollover simulation on eight CPUs. Thus, simulating rollovers using FE method is quickly becoming a reality.

Research on a Rollover Protective Technique for a Vibroseis Truck Based on Reliability Analysis

Research on Rollover Stability and an Anti-Rollover Warning System for the Vibroseis Truck

A Novel Prediction Algorithm for Heavy Vehicles System Rollover Risk Based on Failure Probability Analysis and SVM Empirical Model

Finite element-based safety prediction for hydraulic excavator rollover protective structure and experimental validation

Rollover Prevention and Motion Planning for an Intelligent Heavy Truck

Anti-Rollover Control and HIL Verification for an Independently Driven Heavy Vehicle Based on Improved LTR

Optimization study of tail-lateral occupant injury and restraint system for an off-road vehicle ramp rollover

Integrated control of anti-rollover for high-mobility emergency rescue vehicles

A Vehicle Rollover Evaluation System Based on Enabling State and Parameter Estimation

Research on anti-rollover control of three-axle rescue vehicle based on active suspension and differential braking

Improved Design Of Generalized Dynamic Rollover Threshold Of Multi-Axial Vehicle

Anti-Rollover Warning Control of Dump Truck Lifting Operation Based on Active Suspension

A Research on the Rollover Risk of Motor Vehicles Based on Simulation Analysis

Research on Mathematical Modeling of Critical Impact Force and Rollover Velocity of Coach Tripped Rollover Based on Numerical Analysis Method

A Study of the Vehicle Structure Crashworthiness in Dolly and Curb-Trip Rollover Tests

Braking failure anti-rollover control and hardware-in-the-loop verification of wire-controlled heavy vehicles

Roll stability of all-terrain forklift trucks considering different road types

Development of a Finite Element Model for Simulation of Rollover Crashes

Development of a Refined Rollover Model That Recognizes the Effects of Suspension and Tire Deformation

Research on the speed thresholds of trucks in a sharp turn based on dynamic rollover risk levels

Research on Electric Vehicle Rollover Prevention System Based on Motor Speed Control