Abstract:Rollover crashes are complex by their very nature, and have stimulated many researches aimed at improved occupant safety. In order to investigate the vehicle crashworthiness during rollovers, several test modes are generally used to replicate different real world rollover scenarios. However, such tests are very expensive, especially during the development stage of a new car line. Computer modeling is a cost-effective way to study rollover crashes. However, a survey of literature showed that only rigid-body dynamics based models have been used for rollover simulations. It is well known that this class of models cannot be used to simulate component deformation and structural collapses. Finite element (FE) method, which has been widely used to simulate frontal and side crashes, was rarely used for simulating rollover crashes, due mainly to the relative long duration of a rollover crash. The objective of this study was to develop an FE model for investigating vehicle crashworthiness during three commonly used rollover tests. An FE model of an SUV was developed in this study. Several sub-models, namely the vehicle structure sub-model, the tire sub-model, the suspension system sub-model, the restraint system sub-model, and the dummy model were generated and integrated together. The structure model was first used to simulate the roof crush test as prescribed in FMVSS 216. The resulting load versus roof crush curve matched well against test results. The integrated model was then used to simulate three laboratory-based rollover test modes, namely the SAE J2114 dolly test, curb-trip test, and corkscrew test. For each test mode, up to 1.5 seconds of simulation time (about 1 full vehicle roll) were computed. The vehicle kinematics, including the angular velocity, lateral acceleration, and vertical acceleration during these three test modes were computed and compared with experimental data. The simulated dummy head accelerations, timing and location of the most severe impact to the dummy’s head were also compared with the experimental results. Results showed very good agreement between the tests and simulations. In order to reduce the computational time, multiple CPUs were used. Approximately ten hours were required to run a 1.5 second rollover simulation on eight CPUs. Thus, simulating rollovers using FE method is quickly becoming a reality.

A Vehicle Rollover Evaluation System Based on Enabling State and Parameter Estimation

A Novel Prediction Algorithm for Heavy Vehicles System Rollover Risk Based on Failure Probability Analysis and SVM Empirical Model

Rollover Index for Rollover Mitigation Function of Intelligent Commercial Vehicle’s Electronic Stability Control

Anti-Rollover Control and HIL Verification for an Independently Driven Heavy Vehicle Based on Improved LTR

State Estimation in Roll Dynamics for Commercial Vehicles

Vehicle Rollover Propensity Detection Based on a Mass-Center-Position Metric: A Continuous and Completed Method

Improved Design Of Generalized Dynamic Rollover Threshold Of Multi-Axial Vehicle

Adaptive Estimation of Vehicle Dynamics Through RLS and Kalman Filter Approaches.

Integrated control of anti-rollover for high-mobility emergency rescue vehicles

Analysis of vehicle rollover dynamics using a high-fidelity model

An Integrated Observer for Real-Time Estimation of Vehicle Center of Gravity Height

A layered roll stability control strategy for commercial vehicles based on adaptive model predictive control

Development of a Refined Rollover Model That Recognizes the Effects of Suspension and Tire Deformation

Anti-Rollover Warning Control of Dump Truck Lifting Operation Based on Active Suspension

Optimization study of tail-lateral occupant injury and restraint system for an off-road vehicle ramp rollover

Braking failure anti-rollover control and hardware-in-the-loop verification of wire-controlled heavy vehicles

An Intelligent Predictive Algorithm for the Anti-Rollover Prevention of Heavy Vehicles for Off-Road Applications

Development of a Finite Element Model for Simulation of Rollover Crashes

A Novel Roll and Pitch Estimation Approach for a Ground Vehicle Stability Improvement Using a Low Cost IMU

Rollover prevention control for a four in-wheel motors drive electric vehicle on an uneven road

Research on Mathematical Modeling of Critical Impact Force and Rollover Velocity of Coach Tripped Rollover Based on Numerical Analysis Method