Abstract:A high-pressure shock tube was used to study ignition delay times (IDT) of CH4/O-2/Ar and natural gas/O-2/Ar mixtures behind reflected shock waves. Reaction progress was monitored using sidewall pressure and direct laser absorption diagnostics of CH4 near 3.175 mu m and ethylene near 10.532 mu m. Stoichiometric, fuel-rich and fuel-lean mixtures of CH4/O-2, highly dilute in argon, were studied over a temperature range from 1450 to 1850 K and pressures between 10 and 55 atm. Of note are the experiments conducted with fuel-rich mixtures, as there is a lack of literature data in this regime. In the current study, the methane absorption diagnostic provided a unique tool enabling both speciation of methane and a clear definition of ignition delay time. In addition to methane oxidation, we have measured ignition delay times of commercial natural gas blends over a temperature range of 1408-1541 K, at pressures near 12 atm, and at an equivalence ratio of 1. To understand the effects of minor constituents (such as ethane and propane) in commercial natural gas blends, ethylene concentration during pyrolysis experiments was monitored using a two-wavelength scheme (10.532 mu m and 10.674 mu m) using a CO2 gas laser. The deficiency of existing kinetic models towards predicting the high-temperature kinetics of natural gas blends was highlighted through our measurements. Therefore, this study also provides data critical for refining these models. Extensive sensitivity analysis emphasizes the importance of the reaction CH3+C2H6 -> CH4+C2H5 during natural gas pyrolysis, and the accuracy of the chemical kinetic models is significantly improved by using a revised reaction rate constant (Shao et al. 2019) for this reaction. These measurements extend the test conditions of earlier studies of methane and commercial natural gas. (C) 2020 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

A Shock Tube Study of Ignition Delay Times in Diluted Methane, Ethylene, Propene and Their Blends at Elevated Pressures

A Shock Tube Study of N-Heptane, Iso-Octane, N-Dodecane and Iso-Octane/n-dodecane Blends Oxidation at Elevated Pressures and Intermediate Temperatures

Shock Tube and Kinetic Study of C2H6/H2/O2/Ar Mixtures at Elevated Pressures

Shock Tube Measurements and Kinetic Study on Ignition Delay Times of Lean DME/n-Butane Blends at Elevated Pressures

Autoignition of Iso-Octane at Ultra-Lean and Lean Conditions

Ignition Delay Times of Methane and Hydrogen Highly Diluted in Carbon Dioxide at High Pressures Up to 300 Atm

Shock-induced Ignition and Pyrolysis of High-Pressure Methane and Natural Gas Mixtures

Shock-tube measurements of ignition delay times for the ethane/dimethyl ether blends

Shock-Tube Study of Dimethoxymethane Ignition at High Temperatures

Shock tube measurements and kinetic investigation on the ignition delay times of methane/dimethyl ether mixtures

Experimental And Kinetic Studies On Ignition Delay Times Of Dimethyl Ether/N-Butane/O-2/Ar Mixtures

Ignition Delay Times of Ethane under O2/CO2 Atmosphere at Different Pressures by Shock Tube and Simulation Methods

Experimental and Kinetic Study on Ignition Delay Times of Dimethyl Ether at High Temperatures

Experimental and Numerical Study on the Ignition Delay Times of Dimethyl Ether/ethane/oxygen/carbon Dioxide Mixtures

Experimental and Kinetic Study on Ignition Delay Times of DME/H2/O2/Ar Mixtures

Ignition Delay Time Measurements and Modeling for Gasoline at Very High Pressures

Experimental and modeling study on ignition delays of lean mixtures of methane, hydrogen, oxygen, and argon at elevated pressures

Experimental and Kinetic Study on Ignition Delay Times of Lean N -Butane/hydrogen/argon Mixtures at Elevated Pressures

Experimental and numerical study on the ignition delay times of dimethyl ether/propane mixtures in O2/CO2 atmospheres

Experimental Study on Ethane Ignition Delay Times and Evaluation of Chemical Kinetic Models

An Experimental and Modeling Study of Nitromethane + O 2 + N 2 Ignition in a Shock Tube