Abstract:Particle-reinforced aluminum matrix composites (PRAMCs) always show a low forming stability because the particles are easily separated from the matrix, leaving voids and forming cracks. Extruded in situ PRAMCs are gradually replacing ex situ PRAMCs due to the higher interface bonding between the in situ reinforcements and matrix. In this study, a hot-extruded in situ AA6111 composite with ZrB 2 nanoparticles was obtained from an Al-Zr-B system. The effects of the ZrB 2 content on the geometrically necessary dislocation (GND) density, grain size, grain boundaries, textures and tensile properties of AA6111 composites were researched. The results showed that as the volume fraction of ZrB 2 increased, the mean GND dislocation density increased from 1.53 × 10 15 m −2 to 3.23 × 10 15 m −2 , and most dislocations were located around the ZrB 2 nanoparticle clusters. In addition, an increase in the ZrB 2 content decreased the frequency of high-angle grain boundaries (HAGBs) from 79.28 to 69.45% and increased the frequency of low-angle grain boundaries (LAGBs). ZrB 2 nanoparticle clusters which were located along the grain boundaries promoted continuous dynamic recrystallization (CDRX) and remarkably refined the grains, with the mean size decreasing from 48.2 to 1.8 μm. However, dispersed ZrB 2 nanoparticles inside the grains suppressed CDRX. Tensile tests showed that the properties rose dramatically with an increasing volume fraction of ZrB 2 , and the optimum ultimate tensile strength (UTS), yield strength (YS) and elongation (El) of the 2 vol% ZrB 2 /AA6111 composite were 365 MPa, 280 MPa, and 25.6%, respectively. The mechanisms for CDRX, strengthening and plasticity enhancement were determined and discussed.

Effects of (tib2 + ZrB2) Nanoparticles on Microstructure and Properties of 7055al Matrix Composites

Microstructures and mechanical properties of the in-situ formed nanocomposites of (ZrB2 + Al2O3) and AA7055 alloy

Effects of in Situ Generated ZrB2 Nano-Particles on Microstructure and Tensile Properties of 2024al Matrix Composites

Effects of ZrB2 Nanoparticles on the Microstructures and Tensile Properties of a Hot Extruded In Situ AA6111 Composite

Microstructure evolution and mechanical properties of in-situ ZrB2/Al7085 nanocomposites during hot rolling deformation

Microstructure-property Analysis of ZrB2/6061Al Hierarchical Nanocomposites Fabricated by Direct Melt Reaction

On the Study of a TiB2 Nanoparticle Reinforced 7075al Composite with High Tensile Strength and Unprecedented Ductility

Effects of in-situ ZrB 2 nanoparticles and scandium on microstructure and mechanical property of 7N01 aluminum alloy

Microstructure, mechanical properties and strengthening mechanisms of Mg matrix composites reinforced with in situ nanosized TiB2 particles

Synergistic effect of niobium carbide and titanium nanoparticles on the mechanical and microstructural properties of Al-Zn-Mg-Cu alloy hybrid composites

Effects of Nano-Micron TiB2-Al2Y Particles on the Microstructural Evolution and Mechanical Properties of Extruded Mg-9Y-0.6La Composites

Microstructures and Properties of In-Situ (zrb2 + Al2O3)np/AA6111 Composites Synthesized under Magnetic and Ultrasonic Fields

Microstructure and mechanical properties of an in-situ TiB 2 /Al-Zn-Mg-Cu-Zr composite fabricated by Melt-SHS process

Effect of Nano-Ti Particles on Microstructure and Mechanical Properties of Mg-3Al-1Zn Matrix Composites

Mechanical Properties and Microstructure of in Situ TiB_2-7055 Composites

In Situ Fabrication and Microstucture of ZrB2 Particles Reinforced Aluminum Matrix Composites

Enhanced grain refinement and mechanical properties of a high–strength Al–Zn–Mg–Cu–Zr alloy induced by TiC nano–particles

The Effect of Micron-Sized TiB2 Particles on the Properties of Al6061 Strengthened with 4% TiB2 Nano-TiB2

Microstructure and Tensile Properties of In-Situ TiAl Nanoparticles Reinforced AZ31 Composites

Microstructure Manipulation and Strengthening Mechanism of TiAl Composites Reinforced by Cr Solid Solution and In-Situ Nanometer-Sized TiB2 Particles

In Situ Fabrication and Microstructure of Micro-Nano ZrB2p/Al Composites