Abstract:Owing to their low cost and reduced power losses, floating bush bearings are extensively used in high-speed rotors. The advantages are mainly the result of the rotation of the bush. When shaft speed is within a low speed range, bush rotation speed increases linearly with shaft speed. However, the bush-to shaft speed ratio decreases sharply when the shaft speed reaches a certain range. The mechanism of this phenomenon is not completely clear yet, and a precise prediction method has not been established. The traditional theoretical model predicts that the speed ratio remains constant even when the shaft speed reaches the certain range. Some researchers have attempted to improve the prediction model by considering thermal effect on the assumption that a temperature increase decreases the viscosity of the inner oil film and consequently reduces the speed ratio. However, temperature rise alone is insufficient to induce that much drop of speed ratio. This paper focuses on the effect of air invasion flow in the inner oil film from the axial ends and evaluates the importance of air invasion and thermal effects. Computational fluid dynamics (CFD) modeling is adopted in this study because of its capacity to handle complicated calculation domain and calculate air-oil two-phase flow. Three series of CFD simulations with different models are conducted. These models consider the thermal effect (thermal model), the air invasion effect (air model), and the combination of the thermal and air invasion effects (hybrid model). CFD results of the different models are compared to weigh the importance of each effect. The CFD calculation indicates that a substantial amount of air invades the inner oil film when the shaft speed reaches a certain range. Speed ratio drop is not Caused by a single factor, but it is the result of the combination of the air invasion and thermal effects. Air invasion, which researchers previously ignored, plays a greater role than the thermal effect.

Flow Performance Analysis of Different Air Supply Methods for High Speed and Low Friction Ball Bearing

Effects of oil-air lubrication methods on the internal fluid flow and heat dissipation of high-speed ball bearings

Air Flow Patterns and Noise Analysis Inside High Speed Angular Contact Ball Bearings

Analysis of Oil-Air Two-Phase Flow Characteristics inside a Ball Bearing with Under-Race Lubrication

Investigation on Internal Air Flow Pattern of Angular Contact Ball Bearing with Different Cage Guiding Approaches

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Investigation on the Effect of Sealing Condition on the Internal Flow Pattern of High-Speed Ball Bearing

Numerical Investigation of Two-Phase Flow for the Oil-Air Lubrication Inside an Angular Contact Ball Bearing

Research on internal two‐phase flow in the local micro‐clearance design of a high‐speed ball bearing with under‐race lubrication

Numerical Investigation on Flow Pattern of Air-Oil with Different Viscosities Lubrication

A Simulation Analysis of Ball Bearing Lubrication Characteristics Considering the Cage Clearance

Characteristic Flow Parameters of Oil/Air Lubricants in Bearing Chamber Under Different Flow Patterns

Lubrication and stability analysis of nonlinear rotor-bearing system

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Analysis of Fluid-Thermal Coupling in Ferrofluid Bearing Used in High Speed Machines

Influence of Nozzle Structure on the Two-phase Flow Characteristic in Oil-air Lubrication System for High-speed Rolling Bearing

Visualization Investigation On Flow Field Of Journal Bearing With Partial Texture Surface

Design of groove structures for bearing lubrication enhancement based on the flow mechanism analysis

Analysis on the Fluid/Solid Coupled Heat Transfer and Flow Field of High-speed Sliding Bearings

The Flow Field Simulation Of A Novel Water-Lubricated Hybrid Bearing For High-Speed Spindle

Investigation Of Air-Oil-Thermal Distribution In Floating Bush Bearings