Abstract:The electrochemical properties of glassy carbon (GC) and GC doped with lithium ions (GC:Li+) were investigated as a function of heat‐treatment temperature (HTT). A phenolic resin precursor (liquid resol, C7H8O2) was heat‐treated to 650, 700, 1000, 2000, or 2500 °C to form GC. GC:Li+ was made by dissolving 5% and 10% by weigh LiNO3 in resol (referred to as 5% WLDR and 10% WLDR, respectively) and following the same heat‐treatment programs. Cyclic voltammetry was performed at GC electrodes in aqueous solutions of sulfuric acid and of potassium sulfate together with the electro‐oxidation of potassium ferrocyanide. The hydrogen evolution potential became more negative with rising GC HTT, ranging from −1.2 V for HTT 650 °C to −2.0 V for HTT 2500 °C in both sulfuric acid and potassium sulfate solutions, while hysteresis in the voltammograms was reduced and the oxidation and reduction peaks disappeared. The standard rate constant of ferrocyanide oxidation at a polished electrode surface increased from 6 to 11×10−3 cm s−1 with increasing HTT. On adding lithium ions to the resol, the open‐circuit potentials compared to undoped GC became less positive. In sulfuric acid, new cyclic voltammetric peaks emerged, anodic at +0.6 V and cathodic at +0.3 V vs the standard calomel electrode, indicative of alterations in the bulk structure of the GC matrix. Lithium doping the resin caused GC, upon heating, to lose 9–10% mass, lowered the degree of graphitization at HTTs below the melting points of LiOH and Li2CO3 (∼720 °C), and enhanced graphitization once the lithium compounds melted and diffused away. X‐ray photoelectron spectroscopy results confirmed that no lithium remained in the 5% WLDR samples if the HTT was 1000 °C or higher. Scanning electron microscopy showed that the pore‐diameter distribution of GC:Li+ differed from GC. Inductively coupled plasma atomic emission spectroscopy showed that the 10% WLDR samples heat‐treated to 650 °C had a higher lithium‐ion release rate than those undergoing HTTs to 500 and 575 °C, which identified lithium out‐diffusion as the underlying mechanism of change in the permeability of GC as a function of HTT.

Thermal Evolution of Lithium Ion Substituted Cesium-Based Geopolymer under High Temperature Treatment, Part I: Effects of Holding Temperature

Effects of Li Substitution on the Microstructure and Thermal Expansion Behavior of Pollucite Derived from Geopolymer

Effect of high temperature heating on the microstructure and performance of cesium-based geopolymer reinforced by cordierite

Effect of cesium substitution on the thermal evolution and ceramics formation of potassium-based geopolymer

Early-Stage Geopolymerization Process of Metakaolin-Based Geopolymer

Effects of Na+ substitution Cs+ on the microstructure and thermal expansion behavior of ceramic derived from geopolymer

Celsian Formation from Barium-Exchanged Geopolymer Precursor: Thermal Evolution

Microstructure Evolution Mechanism of Geopolymers with Exposure to High-Temperature Environment

Preparation of fully stabilized cubic-leucite composite through heat-treating Cs-substituted K-geopolymer composite at high temperatures

Effects of high-temperature heat treatment on the microstructure and mechanical performance of hybrid Cf-SiCf-(Al2O3p) reinforced geopolymer composites

Thermal evolution and crystallization kinetics of potassium-based geopolymer

Preparation and characterization of Cf/Pollucite composites through geopolymer precursors

Immobilization Behavior of Sr in Geopolymer and Its Ceramic Product

Disentangling Phase and Morphological Evolution During the Formation of the Lithium Superionic Conductor Li10GeP2S12

Phase transition and thermal stability of ceramics from Na‐based geopolymers

Thermal-mechanical Properties of Short Carbon Fiber Reinforced Geopolymer Matrix Composites Subjected to Thermal Load

Effects of heat-treatment temperature and holding time on the microstructure and mechanical properties of lithium disilicate glass-ceramics

Changes in the Electrochemical Behavior of Polymeric Carbon Induced by Heat‐Treatment and Doping with Lithium Ions

Preparation and in-situ high-temperature mechanical properties of Cf-SiCf reinforced geopolymer composites

Influence of Freeze-Thaw Cycles and High Temperature Exposure on Immobilization Performance of Geopolymer-Zeolite A Composites for Strontium Radionuclide

Effect of Curing Temperature on High-Strength Metakaolin-Based Geopolymer Composite (HMGC) with Quartz Powder and Steel Fibers