Abstract:In order to study the underground coal-gasification process, Aspen Plus software was used to simulate the lignite underground gasification process, and a variety of unit operation modules were selected and combined with the kinetic equations of coal underground gasification. The model can reflect the complete gasification process of the coal underground gasifier well, and the simulation results are more in line with the experimental results of the lignite underground gasification model test. The changes in the temperature and pressure of oxygen, gasification water, spray water, and syngas in pipelines were studied, and the effects of pipe diameters on pipeline conveying performance were investigated as well. The effects of the oxygen/water ratio, processing capacity, and spray-water volume on the components of syngas and components in different reaction zones were studied. In addition, the change tendency of gasification products under different conditions was researched. The results indicate that: (1) The depth of injection and the formation pressure at that depth need to be taken into account to determine a reasonable injection pressure. (2) The liquid-water injection process should select a lower injection pressure. (3) Increasing the oxygen/water ratio favors H2 production and decreasing the oxygen/water ratio favors CH4 production. (4) The content of CO2 is the highest in the oxidation zone, the lowest in the reduction zone, and then increases a little in the methanation reaction zone for the transform reaction. The content of CO is the lowest in the oxidation zone and the highest in the reduction zone. In the methanation reaction zone, CO partially converts into H2 and CO2, and the content of CO is reduced. (5) The injection of spray water does not affect the components of the gas but will increase the water vapor content in the gas; thus, this changes the molar fraction of the wet gas.

The BLEVE Research of Reaction Runaway Based on the Aspen Plus-Fluent

Consequence Analysis of Derivative Accidents Due to Reaction Runaway

A Detailed Finite Element Model of Internal Short Circuit and Venting During Thermal Runaway in a 32650 Lithium-Ion Battery

Analysis of batch reactor thermal runaway scenario based on synthesis reaction of isopropyl propionate

CFD Simulation to Study Batch Reactor Thermal Runaway Behavior Based on Esterification Reaction

Study on the Flammability Limits of Lithium-Ion Battery Vent Gas under Different Initial Conditions

Thermal Risk Assessment of the Complex Nitration Process Through Safety Operating Space Analysis and Optimization

Case study of fire and explosion accident based on damage consequence and numerical results: Explosion medium traceability

Thermal risk in batch reactors: Theoretical framework for runaway and accident

Research on Thermal Runaway Process of Styrene Bulk Polymerization

Rigorous dynamic simulation methodology for scenario-based safety analysis of pressure-swing distillation considering independent protections

Modeling and Simulation of a Gas-Exhaust Design for Battery Thermal Runaway Propagation in a LiFePO4 Module

Influence of Thermal Stratification by Fire on Heat-Mass Coupling Response Mechanism of the Liquefied Tank

Potential Risk Evaluation of Thermal Explosion for Exothermic Reaction System

Hazard analysis on LPG fireball of road tanker BLEVE based on CFD simulation

Safety relief analysis for methanol-acetic anhydride system by stationary methods and dynamic simulation

Fireball modeling and thermal hazards analysis of leaked 1,1-difluoroethane in fluorine chemical industry based on FDS

Simulation of Process for Preparing Sodium Methoxide Using Aspen Plus

Mechanism Research Of Boiling Liquid Expanding Vapor Explosion

Investigating the Inherent Safety Designs of Typical Exothermic Reaction Processes

Simulation of Underground Coal-Gasification Process Using Aspen Plus