Abstract:It has been reported that applying a certain external anodic potential over un-doped (alpha-Fe2O3) and Ti-doped alpha-Fe2O3 (Ti-Fe2O3) electrodes can improve the photocurrent or the photoelectrochemical oxidation rate of water. However, it is assumed in the literature that the potential drops completely across the side of the solid semiconductor (band edge pinning), and the influence of the potential on the interfacial charge-transfer rate constant is rarely reported. In this article, the impact of the applied potential on the interfacial charge-transfer rate constant during photoelectrochemical oxidation of water over the two electrodes was investigated by electrochemical impedance spectroscopy. The results showed that by increasing the applied anodic potential, the interfacial charge-transfer rate constants for both electrodes were increased. The smaller increase in the magnitude of the rate constant than determined by theory indicates that not all of the applied potential drops across the Helmholtz layer, but takes place in both the space charge and Helmholtz layers simultaneously (Fermi level pinning). The results of the surface-state capacitance measurements suggested that the photo-generated charge can be accumulated in the surface states, resulting in the re-distribution of the potential at the interface and an improvement in the rate constant. Under the same applied potential, the higher the light intensity is, the more the photogenerated holes accumulated in the surface states. This causes an increase in the potential drop across the Helmholtz layer and consequently increases the charge-transfer rate constant. Compared with the alpha-Fe2O3, the improvement of the charge-transfer rate constant by the anodic potential is more obvious.

Insight into the Influence of High Temperature Annealing on the Onset Potential of Ti-doped Hematite Photoanodes for Solar Water Splitting

Doping and Annealing Conditions Strongly Influence the Water Oxidation Performance of Hematite Photoanodes

Origin of High-Efficiency Photoelectrochemical Water Splitting on Hematite/Functional Nanohybrid Metal Oxide Overlayer Photoanode after a Low Temperature Inert Gas Annealing Treatment.

Evaluating high temperature photoelectrocatalysis of TiO 2 model photoanode

Ti, Zn Co-Doped Hematite Photoanode for Solar Driven Photoelectrochemical Water Oxidation

Influence of the Potential on the Charge-Transfer Rate Constant of Photooxidation of Water over Α-Fe2o3 and Ti-Doped Α-Fe2o3

Cathodic Shift of Onset Potential for Water Oxidation on A Ti4+ Doped Fe2o3 Photoanode by Suppressing the Back Reaction

Effect of Annealing Temperature on the Photoelectrochemical Properties of Dye-Sensitized Solar Cells Made with Mesoporous TiO2 Nanoparticles

Enhancement of the Solar Water Splitting Efficiency Mediated by Surface Segregation in Ti-doped Hematite Nanorods

Cathodic Shift of A Photo-Potential on A Ta3n5 Photoanode by Post-Heating A Tio2 Passivation Layer

Insights into Improving Photoelectrochemical Water‐Splitting Performance Using Hematite Anode

Identifying Water Oxidation Mechanisms at Pure and Titanium‐Doped Hematite‐Based Photoanodes with Spectroelectrochemistry

The Influence of Ti Doping on Morphology and Photoelectrochemical Properties of Hematite Grown from Aqueous Solution for Water Splitting

Nonequilibrium Ti4+ Doping Significantly Enhances the Performance of Fe2O3 Photoanodes by Quenching

Analyzing the Temperature Dependence of Titania Photocatalysis: Kinetic Competition between Water Oxidation Catalysis and Back Electron-Hole Recombination

New Findings for the Much‐Promised Hematite Photoanodes with Gradient Doping and Overlayer Elaboration

Identifying the Spectroelectrochemical Characteristics of Hematite Photoanodes for Water Oxidation

Defect segregation and its effect on the photoelectrochemical properties of Ti-doped hematite photoanodes for solar water splitting

Grey hematite photoanodes decrease the onset potential in photoelectrochemical water oxidation

Tuning of oxygen vacancy-induced electrical conductivity in Ti-doped hematite films and its impact on photoelectrochemical water splitting

Improving Hematite-Based Photoelectrochemical Water Splitting with Ultrathin TiO2 by Atomic Layer Deposition.