Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Bubble‐separation Dynamics in a Planar Cyclone: Experiments and CFD Simulations

Cfd Simulation of Bubble Dynamics in Bubble Columns with Internals

Improvement of the Bubble Separation Through Eccentric Planar Cyclones: Experiments and CFD Simulations

Impact of eccentricity on bubble size, gas hold-up, and separation efficiency in a planar cyclone

Analysis of Bubble Flow Mechanism and Characteristics in Gas–Liquid Cyclone Separator

Impact of Bubble Coalescence on Separation Performance of a Degassing Hydrocyclone

Computational Fluid Dynamics Simulation of the Impact of Structure on the Degassing Efficiency of a Cyclone

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Dynamics of bubbles detached from non-circular orifices: Confinement effect of orifice boundary

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

Direct numerical simulation of deformable rising bubbles at low Reynolds numbers

3D turbulent flow modeling in the separation column of a circumfluent cyclone

Performance of a Degassing Cyclone with Main and Subsidiary Chambers

Bubbly Flow in Degassing Cyclones and Potential Applications

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Numerical study of gas-solid flow in a radial-inlet structure cyclone separator

Instantaneous Separation Model of a Square Cyclone

Spatio-temporal dynamics of turbulent separation bubbles

A study on gas flow in spiral inlet cyclone separator

Modeling and Simulation of Multiple Bubble Entrainment and Interactions With a Traveling Vortex Ring

Analyses of Bubble Dynamics in Subcooled Boiling Flow Using Euler-Lagrange Method