Abstract:The honeycomb catalysts of La0.8 Ca0.2 FeO3/MgAl2O4 were developed by washcoating the composite powders of La0.8 Ca0.2 FeO3 (LCF)perovskite and MgAl2O4 spinel onto the honeycomb substrates fabricated with the metallic wire mesh and applied for catalytic combustion of air diluted methane (0.5％).First,the composite powders of LCF/MgAl2 O4 were prepared by deposition-precipitation method.The activity of the composite powder was measured in the Temperature-Programmed Micro Reactor (TPRS) and the properties were characterized by XRD,BET,SEM,and TPR in an effort to optimize the molar ratio of LCF to MgAl2O4 and the proper calcination temperature of the composite.It was found that after compositing with MgAl2O4,the thermal resistance of LCF was improved substantially,and its activity quantified by the pseudo-first-order reaction rate constant (k,L· g-1· s-1) almost doubled.Afterwards,the wire-mesh honeycomb substrate modules were dip-coated sequentially by slurries of MgAl2 O4 and LCF/ MgAl2 O4 composite powders,respectively.Influences of the calcination temperature of the composite powder before ball-milling and loadings of MgAl2 O4 and composite powder coatings were investigated.For comparison,the catalytic combustion of 0.5％ methane was carried out at GHSV of 40000 h-1 for both wire-mesh and ceramic honeycomb catalysts,where the activity of the catalyst on wire-mesh substrate was 48.1％ higher at 600 ℃.Finally,the performance of the wire-mesh honeycomb was examined in a time-on-stream test for 500 hours.The activity was dropped by 20.3％ in the initial 200 hours,and then stablized for the remaining 300 hours.

Methane Combustion with Cobalt-Substituted Barium-Lanthanum Hexaaluminate Catalysts Supported on Porous Monolithic Honeycombs

Catalytic combustion of methane over hexaaluminates Ba 1x La x Al 11 O 19 ± δ supported on mullite honeycomb

La0.8Ca0.2FeO3/MgAl2O4 Wire-Mesh Honeycomb for Catalytic Combustion of Air Diluted Methane

Preparation and catalytic activities of Lanthanum strontium manganite based catalysts supported on honeycomb ceramics

La0.8Ca0.2FeO3/MgO honeycombs for catalytic lean burn of methane

Study on the Structure and Methane Combustion Activity of Hexaaluminates Catalysts La_(1-x)Sr_xMnAl_(11)O_(19-δ)

Characteristics of Premixed Catalytic Combustion of Nature Gas

Preparation of La_xCa_yBa_zMn_2Al_(10)O_(19-δ) Catalysts and Their Catalytic Activity for Methane Combustion

Catalytic Combustion of Low Concentration Methane over Catalysts Prepared from Co/Mg-Mn Layered Double Hydroxides

Effect of Water Content on the Catalytic Property of LaMnAl_(11)O_(19-δ) for Methane Combustion

Enhanced activity and stability of La-doped CeO2 monolithic catalysts for lean-oxygen methane combustion

Catalytic oxidation of methane over hexaaluminates and hexaaluminate-supported Pd catalysts

The Preparation Effect on Activity and Thermal Stability of La0.8Ca0.2FeO3 Perovskite Honeycombs Dispersed by MgAl2O4 Spinel Washcoat for Catalytic Combustion of Dilute Methane

Partial oxidation of methane to synthesis gas over Co/Ca/Al2O3 catalysts

Promotion effect of different lanthanide doping on Co/Al2O3 catalyst for dry reforming of methane

Low temperature complete combustion of methane over cobalt chromium oxides catalysts

Effects of partial substitution of Cu by Mn and Co in LaCu0.5Ni0.5O3 catalyst synthesized by mechanochemical method in the total oxidation of methane

Preparation of Ce and Mn Substituted Hexaaluminate Catalysts for Natural Gas Combustion by Reverse Microemulsion

Tailoring Pd/M@CoAlO Core-Shell Catalyst Morphology for Efficient Methane Oxidation

Plasma assisted preparation of cobalt catalysts by sol–gel method for methane combustion

Silver–Cobalt Oxides Derived from Silver Nanoparticles Deposited on Layered Double Hydroxides for Methane Combustion