Abstract:A series of Co3O4/gamma-Al2O3 catalysts with different Co3O4 loadings were prepared by incipient wetness impregnation (IWI) and a combination of IWI and subsequent combustion synthesis (CS), and tested for catalytic combustion of CH4. The IWI/CS-X (X=5, 10, 30 and 50, represented the Co3O4 loading as wt%) samples prepared via IWI/CS method exhibited higher catalytic activity than the IWI-X (X 5, 10, 30 and 50) ones via IWI method. IWI/CS-30 showed the highest catalytic activity with T-10 (10% CH4 conversion) at 300 degrees C and T-100 (complete conversion) at 550 degrees C. The structure characterization indicated the IWI/CS-X catalysts had a greater surface area with relatively lower Co3O4 crystallization and better Co3O4 dispersion compared with IWI-X samples. X-ray photoelectron spectroscopy (XPS) and UV-vis results revealed that surface Co3+/(Co2+ + Co3+) ratios of the IWI/CS-X samples was relatively higher than those of IWI-X ones. The surface Co3+ of the IWI/CS-X catalysts was easily reduced to Co2+ at 280-330 degrees C, whereas, only one difficult reduction process of Co304 to Co was observed at 400-600 C for all of the IWI-X samples according to hydrogen temperature-programmed reduction (H-2-TPR) results. Hence, the abundance of surface Co3+, easy and fast redox cycle between Co2+ and Co3+ at low temperatures were the underlying mechanisms for the excellent catalytic performance of IWI/CS-X catalysts in CH4 combustion. (C) 2014 Elsevier B.V. All rights reserved.

Low temperature complete combustion of methane over cobalt chromium oxides catalysts

Catalytic Performance of Manganese Cobalt Oxides on Methane Combustion at Low Temperature

Low-Temperature Methane Combustion Using Ozone over Coβ Catalyst

Catalytic Combustion of Methane over Cerium-Doped Cobalt Chromite Catalysts

Roles of Li + and Zr 4+ cations in the catalytic performances of Co 1-xM xCr 2O 4 (M = Li, Zr; X = 0-0.2) for methane combustion

Partial oxidation of methane to synthesis gas over Co/Ca/Al2O3 catalysts

Engineering MOx/Ni Inverse Catalysts for Low-Temperature CO2 Activation with High Methane Yields

Low temperature activation of methane to hydrogen depending on tailored electron transfer over Ni–Cr composite oxide

Low-temperature combustion of methane over graphene templated Co3O4 defective-nanoplates

Cobalt promoted Ni/MgAl2O4 catalyst in lean methane catalytic oxidation

Catalytic Combustion of Low Concentration Methane over Catalysts Prepared from Co/Mg-Mn Layered Double Hydroxides

Advancing catalytic oxidation of lean methane over cobalt-manganese oxide via a phase-engineered amorphous/crystalline interface

Distinguished Roles with Various Vanadium Loadings of Cocr2-Xvxo4 (X=0-0.20) for Methane Combustion

Oxidation of methane over Pd/mixed oxides for catalytic combustion

The Influence of Reduction Temperature on the Performance of ZrOx/Ni-MnOx/SiO2 Catalyst for Low-Temperature CO2 Reforming of Methane

Catalytic combustion of lean methane over MnCo2O4/SiC catalysts: Enhanced activity and sulfur resistance

Synthesis, Characterization, and Catalytic Evaluation of Co 3 O 4 /Γ-Al 2 O 3 As Methane Combustion Catalysts: Significance of Co Species and the Redox Cycle

Complete Oxidation of Methane on Co 3 O 4 -Sno 2 Catalysts

Preparation of Mn-Doped Co3O4 Catalysts by an Eco-Friendly Solid-State Method for Catalytic Combustion of Low-Concentration Methane

Facile synthesis of palladium incorporated NiCo2O4 spinel for low temperature methane combustion: Activate lattice oxygen to promote activity

Cobalt–Magnesium Oxide Catalysts for Deep Oxidation of Hydrocarbons