Abstract:Hydrophobicity is the most important property of silicone rubber for outdoor isolation. Controlling wettability, along with interface and adhesion studies, has been widely investigated for technological applications, such as self-cleaning surfaces, by modifying the geometric structure and chemical composition of surfaces. Superhydrophobic surface with self-cleaning and anti-icing properties is ideal for outdoor insulation material. This paper reports on an effective strategy to modify the surface structure of silicone rubber. Microcraters with nanotexture can be fabricated on a mold steel using high-power picosecond laser incorporated with a high-speed scanning mirror. This template is used in direct replication process in which the surface morphology of silicone rubber can be changed during vulcanization. Two accessible methods are used to implement the modification process. Single-point pulse method is used to prepare regular papilla and abundant nanotexture on open architecture-type superhydrophobic surface, with contact angle reaching 151.5°±1.7°. Line scanning method is used to prepare connected papillae on enclosed-type surface, forming the secondary structure. In this case, nanotexture is richer and has a smaller scale (100 nm) compared with open architecture-type surface. Moreover, the contact angle of the enclosed-type superhydrophobic surface is 150.3°±0.9°. The contact model of water on superhydrophobic surfaces follows the Wenzel and Cassie coexisting model as shown by the air pockets, which are found experimentally and by calculation. Sliding angle of superhydrophobic surfaces reaches 5°, which indicates that this insulating surface possesses good self-cleaning properties. Repeated and large-area fabrication of superhydrophobic silicone rubber can be achieved by the proposed methods. These methods can be performed for large-scale application.

Effect of Superhydrophobicity on Surface Damage of Silicone Rubber under AC Voltage

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Effect of superhydrophobicity on flashover characteristics of silicone rubber under wet conditions

Dynamic Behavior of Water Droplets and Flashover Characteristics on a Superhydrophobic Silicone Rubber Surface

Influence of AC and DC Voltage Superposition on Partial Discharge of Composite Insulator

Effect of Superhydrophobic Surface on the Surface Trap Distribution of Silicone Rubber Composites

Effect of Hydrophobicity on Electric Field Distribution and Discharges along Various Wetted Hydrophobic Surfaces

The Effect of Water Droplets on Hydrophobic Contaminated Surface under AC Field Voltage Application

Characteristics of Charge Dissipation on Super-Hydrophobic Surface of Silicone Rubber and Its Influence on Hydrophobicity

Aging and recovery of superhydrophobic silicone rubber under electrical and non-electrical stresses

Flashover characteristics of discrete water droplets on the surface of super-hydrophobic silicone rubber

Surface Discharge Of Silicone Rubber Under Polluted Conditions

Aging and Self-Healing Properties of Superhydrophobic Silicone Rubber

Influence of alternating current (AC) corona discharge on the superhydrophobicity of SiO2/fluorosilicon resin nano-composite coating

A superhydrophobic surface with aging resistance, excellent mechanical restorablity and droplet bounce properties

Degradation Progress of Silicon Rubber Surface Properties under DC Contamination Flashover

Suppression of surface charge on micro- and nano-structured superhydrophobic silicone rubber

A high reliability super hydrophobic silicone rubber

Effects of AC and DC Corona on the Surface Properties of Silicone Rubber: Characterization by Contact Angle Measurements and XPS High Resolution Scan

Preparation and Basic Properties of Superhydrophobic Silicone Rubber with Micro-Nano Hierarchical Structures Formed by Picosecond Laser-Ablated Template

Influence of Surface Roughness on Superhydrophobicity of Silicone Rubber Surface