Abstract:Summary form only given. The fast electrical explosion of a single metal wire has important applications in many fields, e.g., wire-array Z-pinch, x-rays source, and material property in extreme conditions, etc. The experimental and numerical investigations on nanosecond electrical explosion of single thin aluminum wire are presented in this paper. The experiments are conducted under a negative-polarity current with current ratio of 90-170A/ns. The deposited energy is calculated by integrating the product of resistivity voltage and current. The aluminum plasma is investigated using a picosecond laser probe. A one-dimensional magnetohydrodynamic model, which describes the severe phase transition from solid state into exploding plasma, is also adopted to investigate the process of exploding wire. Thomas-Fermi equation of state with quantum and exchange corrections, which allows the phase transition from solid to plasma state to be approximately simulated, is adoptted 1 . The Lee-More conductivity model with Dasjarlais's correction is used as well. The hydrodynamic equations are solved using the NND method proposed by Zhang. Four stages are suggested in this model according to the temperature and phases, namely, the solid stage, the transition stage from solid to liquid, the liquid stage and the plasma formation stage. Thermodynamical calculation is carried out during the solid state of Al wire. When the temperature is above the melting point, the dense core, gaseous metal, and the plasma are treated as fluid. The grid is labeled as vacuum when the density is lower than 10 -4 kg/m 3 . The numerical results are compared with the experimental results, and the important features of the core and corona are analyzed.

Measuring the Dynamic Polarizability of Tungsten Atom Via Electrical Wire Explosion in Vacuum

Measurement of dynamic atomic polarizabilities of Al at 19 wavelengths from 420 nm to 680 nm in electrical exploding wire experiments

Study of Density Distribution of Electrical Exploding Tungsten Wire in Air

Using of Fiber-Array Diagnostic to Measure the Propagation of Fast Axial Ionization Wave During Breakdown of Electrically Exploding Tungsten Wire in Vacuum

Factors Affecting The Exploding Characteristics Of Tungsten Wires With Negative-Polarity Current

Transforming Dielectric Coated Tungsten and Platinum Wires to Gaseous State Using Negative Nanosecond-Pulsed-Current in Vacuum

Explosion Symmetry Improvement of Polyimide-Coated Tungsten Wire in Vacuum on Negative Discharge Facility

Evolution of the Electrically Exploding Wire Observed with a Mach–Zehnder Interferometer

Experimental and Numerical Investigations on the Fast Electrical Explosion of Single Aluminum Wire in Vacuum

High-Speed Imaging of Transition from Fluid Breakup to Phase Explosion in Electric Explosion of Tungsten Wires in Air

Measurement of the mass density evolution of wire explosion using X-ray backlight

INFLUENC OF DIELECTRIC COATING AND SOLDERING ON ELECTRICAL EXPLOSION OF TUNGSTEN WIRES

Study on Electrical Explosion of Bare and Insulation Coated Tungsten Wires

Fully Vaporized Electrical Explosion of Bare Tungsten Wire in Vacuum

Mass Density Evolution of Wire Explosion Observed Using X-Ray Backlight

The Explosive Eletrical Characteristics Test Research on Electric Exploding Copper Wire

Atomization and merging of two Al and W wires driven by a 1 kA, 10 ns current pulse

Experiment measuring the energy deposition and expansion rate of exploding copper wires in vacuum using negative polarity current

Study of the Relationship Between Maximum Specific Energy and Wire Diameter During Electrical Explosion of Tungsten Wires

Experimental Investigation on the Electrical Explosion of Single Aluminum Wire in Vacuum

Observation of Fast Expansion Velocity with Insulating Tungsten Wires on ∼80 Ka Facility