Abstract:The China Fusion Engineering Test Reactor (CFETR) is a new tokamak device whose magnet system includes toroidal field, central solenoid (CS) and poloidal field coils. The main goal is to build a fusion engineering tokamak reactor with about 1 GW fusion power and self-sufficiency by blanket. In order to reach this high performance, the magnet field target is 15 T. However, the huge electromagnetic load caused by high field and current is a threat for conductor degradation under cycling. The conductor with a short-twist-pitch (STP) design has large stiffness, which enables a significant performance improvement in view of load and thermal cycling. But the conductor with STP design has a remarkable disadvantage: it can easily cause severe strand indentation during cabling. The indentation can reduce the strand performance, especially under high load cycling. In order to overcome this disadvantage, a new design is proposed. The main characteristic of this new design is an updated layout in the triplet. The triplet is made of two Nb3Sn strands and one soft copper strand. The twist pitch of the two Nb3Sn strands is large and cabled first. The copper strand is then wound around the two superconducting strands (CWS) with a shorter twist pitch. The following cable stages layout and twist pitches are similar to the ITER CS conductor with STP design. One short conductor sample with a similar scale to the ITER CS was manufactured and tested with the Twente Cable Press to investigate the mechanical properties, AC loss and internal inspection by destructive examination. The results are compared to the STP conductor (ITER CS and CFETR CSMC) tests. The results show that the new conductor design has similar stiffness, but much lower strand indentation than the STP design. The new design shows potential for application in future fusion reactors.

Ongoing Efforts at Internal-Tin Nb3Sn Strand With Higher Jcn and Lower Hysteresis Loss

Performance Optimization of Internal Tin Process Multifilamentary Nb3Sn Strands

Heat Treatment and Structure Optimizations of Internal Tin Nb3Sn Superconducting Strands in WST

Effect of Nb3Sn Coarse Grains on Critical Current Densities of Internal Tin Nb3Sn Strand

Optimization of Bronze Processed ${\hbox {nb}}_{3}{\hbox {sn}}$ Strand for ITER at WST

Progress on Internal-Tin Route Nb3Sn Superconducting Strand for ITER in China

Effect of Twist Process on Critical Current and Hysteresis Loss of Nb3sn Strands

Fabrication and Characterization of Internal Sn and Bronze-Processed Nb3Sn Strands for ITER Application

Development of Internal Tin Nb3Sn Strand for CRAFT in WST

An Investigation Into The Heat Treatment Tolerance Of Wst Nb3sn Strands Produced For Massive Fusion Coils

Status of Internal-Tin Nb3Sn Strand for Divertor Tokamak Test Facility

New Progress of Nb3sn Strand Production for Iter in Wst

Impact of local plastic deformation on thermo-magnetic instability of high-J c Nb 3 Sn strand

Impact of Local Plastic Deformation on Thermo-Magnetic Instability of High-J C Nb3Sn Strand

Fabrication of Low AC Loss Cu0.5Mn-Based NbTi Superconducting Strands

Microstructure and superconducting properties comparison of bronze and internal tin process Nb3Sn strands for ITER

Development of multifilamentary niobium–titanium and niobium–tin strands for the International Thermonuclear Experimental Reactor project

Indentation Effects on Strain Sensitivity of Critical Current for Internal-Tin Nb3Sn Strand

Magnetization Study of Iter-Type Internal-Sn Nb3sn Superconducting Wire

Development of Electromagnetic Forming Nbti Superconducting Joint

New Design of Cable-in-conduit Conductor for Application in Future Fusion Reactors