Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Vehicle State Estimation of Steer by Wire System Based on Multi Sensor Fusion

State Estimation of Drive-by-Wire Chassis Vehicle Based on Dual Unscented Particle Filter Algorithm

Fault Diagnosis and Fault-Tolerant Compensation Strategy for Wheel Angle Sensor of Steer-by-Wire Vehicle via Extended Kalman Filter

Fault-Tolerant Control for Intelligent Electrified Vehicles Against Front Wheel Steering Angle Sensor Faults During Trajectory Tracking

A model predictive control approach for angle tracking of steer‐by‐wire system with nonlinear transmission ratio

Steer-by-wire control algorithm using a dual-layer closed-loop model

State Estimation of Distributed Drive Electric Vehicle Based on Adaptive Kalman Filter

A Model-Tuned Predictive Backstepping Control Approach for Angle Following of Steer-by-Wire

A bilateral control scheme for vehicle steer-by-wire system with road feel and steering controller design

DGPS-Based Vehicle State Estimation in V2I Cooperative System

Vehicle State Estimation Using Interacting Multiple Model Based on Square Root Cubature Kalman Filter

Model-Based Integrated Control With Vehicle States And Parameters Estimation

State Estimation for 4WD Vehicle Based on Information of Tyre Force Sensor

Real-Time Estimation Of Vehicle'S Lateral Dynamics At Inclined Road Employing Extended Kalman Filter

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

Adaptive Estimations of Tyre–road Friction Coefficient and Body’s Sideslip Angle Based on Strong Tracking and Interactive Multiple Model Theories

The Steering Actuator System to Improve Driving of Autonomous Vehicles based on Multi-Sensor Data Fusion

Robust Steering Angle Tracking Control for Steer-by-wire System

State Parameter Estimation of Intelligent Vehicles Based on an Adaptive Unscented Kalman Filter

Vehicle state and parameter estimation based on double cubature Kalman filter algorithm

Vehicle sideslip angle estimation for a four-wheel-independent-drive electric vehicle based on a hybrid estimator and a moving polynomial Kalman smoother