Abstract:The low GWP (Global Warming Potential) refrigerant R1234ze(E) is a potential alternative of R134a. This study puts the emphasis on the comparison of the flow boiling pressure drop and heat transfer of R134a and R1234ze(E) in a dimpled flat duct. For the air-conditioning applications, the experiments are conducted at mass flux from 100 to 200 kg m(-2) s(-1) , saturation temperature from 5 to 15 degrees C, heat flux from 2.5 to 10 kW m(-2), and vapor quality from 0.1 to 0.95. The results show that the frictional pressure gradient of R1234ze(E) is 1.10 to 1.27 times that of R134a. The characteristics of the flow boiling heat transfer coefficient of R1234ze(E) are similar to R134a. The increasing flow boiling heat transfer coefficient with vapor quality in the tested range implies the convective evaporation dominates the heat transfer. It is also observed that the flow boiling heat transfer coefficient visibly increases with a rise in mass flux and decreases with the saturation temperature increment due to the increase in vapor to liquid density ratio. The enhancement effect of heat flux on the flow boiling heat transfer shows up at the highest value of 10 kW m(-2) only. The heat transfer coefficient ratio of R1234ze(E) to R134a increases from 0.89 to 1.20 with an increase in vapor quality. The comparison of frictional pressure gradient and heat transfer characteristics between R1234ze(E) and R134a has been discussed from the viewpoint of fluid properties. (C) 2020 Elsevier Ltd and IIR. All rights reserved.

Heat Capacity of R1234ze(E) at Temperatures from 313 to 393 K and Pressures Up to 10 MPa

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Measurement of the Heat Capacity of R1233zd(E)

Comparison of Flow Boiling Pressure Drop and Heat Transfer of R134a with Low GWP Alternative R1234ze(E) in a Dimpled Flat Duct

Isobaric Heat Capacity Measurements for R1234yf from 303 to 373 K and Pressures Up to 12 Mpa

Measurements of Isobaric Heat Capacity of R143a and R227ea at Liquid Phase by Quasi-Steady Scanning

Isothermal Vapor–Liquid Equilibria of the Absorption Working Pairs (r1234yf + NMP, R1234yf + DMETrEG) at Temperatures from 293.15 K to 353.15 K

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Isobaric Heat Capacities of R245fa and R236fa in Liquid Phase at Temperatures from (315 to 365) K and Pressures Up to 5.5 MPa

Isobaric Heat Capacity of HFC-161 in the Liquid Phase at Temperatures Up to 360.15 K and Pressures Up to 5.5 MPa

Flow Boiling Heat Transfer Characteristic of Refrigerant R1234ze(E) in Horizontal Circular Tube

Thermal conductivity measurements for trans-1,3,3,3-Tetrafluoropropene (R1234ze(E)) in liquid phase

Measurements of Surface Tension of R1234yf and R1234ze(E)

Investigation on the Performance of R1234ze(E) in Absorption Refrigeration and Ejection Refrigeration Systems

Viscosity Measurements for 2,3,3,3-Tetrafluoroprop-1-ene (r1234yf) and Trans-1,3,3,3-tetrafluoropropene (R1234ze(e))

Thermal Diffusivity Measurements of R1234yf and R1234ze(E) under Saturation Conditions Using Dynamic Light Scattering Method

Experimental Isobaric Heat Capacity of Liquid HFC-32+HFO-1234ze(E) Mixture and Extension of a Predictive Corresponding State Equation to HFC Mixtures

PVTx Properties of the R245fa/R1234ze(E) for Low-Temperature Organic Rankine Cycle

Thermal Conductivity of Binary Mixtures of 1,1,1,2-Tetrafluoroethane(R-134a), 2,3,3,3-Tetrafluoropropene (R-1234yf), and trans-1,3,3,3-Tetrafluoropropene (R-1234ze(E)) Refrigerants

Experimental Pvt Property for the Liquid HFO1234ze(E) Using the Isochoric Method