Abstract:Aiming for the application of refrigerant two-phase cooling on battery thermal management, this study presented an experimental investigation on the flow boiling characteristics of R1233zd(E) in a parallel mini-channel heat sink, which consisted of 21 channels with the length of 140 mm and the cross section of 1.5 x 1.5 mm(2). Under the saturation pressure of 125 kPa, the boiling curve of R1233zd(E) and the heat transfer coefficient were analyzed under different heat fluxes (5-100 kW/m(2)), mass fluxes (150-600 kg/m(2) s) and inlet subcoolings (2.5-8 K). In addition, the flow pattern was captured using high-speed camera. The results showed that the onset of nucleate boiling was delayed with the increase of refrigerant mass flux and inlet subcooling, while the transition of heat transfer was verified by flow pattern visualization. The measured wall superheat was compared with present correlations, showing that the predicted value was always smaller than the experimental results. Flow boiling on local points showed that the nucleate boiling was triggered later at the channel located at the center axis of the heat sink, meanwhile the approach of critical heat flux was more obvious at channel outlet. Due to the graduate transition of flow boiling mechanism, refrigerant mass flux had limited influence on the local heat transfer coefficient when the heat flux was lower than 30 kW/m(2), while enhancement on heat transfer could be observed with larger mass flux when the heat flux exceeded 30 kW/m(2). The local experimental data of heat transfer coefficient were compared with 6 correlations from the literatures. It was found that the best prediction was presented by Liu and Winterton model with a MAE of 23.4%, while Kim and Mudawar model showed best agreement under different mass fluxes. A simple modification was conducted on Kim and Mudawar model, and the calibrated model presented a better prediction accuracy with the MAE of 17.6% and 83.2% of total data within the error of +/- 30%. (C) 2021 Elsevier Ltd. All rights reserved.

Measurement of the Heat Capacity of R1233zd(E)

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Measurements of Isobaric Heat Capacity of R143a and R227ea at Liquid Phase by Quasi-Steady Scanning

Heat Capacity of R1234ze(E) at Temperatures from 313 to 393 K and Pressures Up to 10 MPa

Isobaric Heat Capacity Measurements for R1234yf from 303 to 373 K and Pressures Up to 12 Mpa

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Isobaric Heat Capacity of HFC-161 in the Liquid Phase at Temperatures Up to 360.15 K and Pressures Up to 5.5 MPa

Experimental Investigation on Flow Boiling Instability of R1233zd(E) in a Parallel Mini-Channel Heat Sink for the Application of Battery Thermal Management

Isobaric Heat Capacities of R245fa and R236fa in Liquid Phase at Temperatures from (315 to 365) K and Pressures Up to 5.5 MPa

Measurements of Isochoric Specific Heat Capacity for 3,3,3-Trifluoroprop-1-ene (r1243zf) at Temperatures from (250 to 300) K and Pressures Up to 10 MPa

Measurement of Phase Equilibrium for R-1233zd(E) with Three Pure Esters between 298.15 and 343.15 K

Thermal conductivity measurements for trans-1,3,3,3-Tetrafluoropropene (R1234ze(E)) in liquid phase

Heat Capacity of Isobutane in Liquid Phase at Temperatures from 303 K to 413 K and Pressures Up to 12 MPa

Thermal Diffusivity Measurements of R1234yf and R1234ze(E) under Saturation Conditions Using Dynamic Light Scattering Method

Experimental Measurement and Theoretical Calculation of Solubility and Diffusion Coefficient of R1233zd(E) in [HMIM][PF6]

Measurement Device for Heat Capacities of HFC152a/HCFC22 Liquid Mixture

Experimental Investigation on the Isobaric Molar Heat Capacities of [EMIM][BF4] and [hmim][tf2n] with Dissolved R32 or R125

Experimental Isobaric Heat Capacity of Liquid HFC-32+HFO-1234ze(E) Mixture and Extension of a Predictive Corresponding State Equation to HFC Mixtures

Flow Boiling Heat Transfer Characteristic of Refrigerant R1234ze(E) in Horizontal Circular Tube

Measurement of Isobaric Heat Capacity of Pure Water Up to Supercritical Conditions