Abstract:To achieve highly stable anion conductive membranes, p-quaterphenylene moiety was copolymerized into the poly(arylene alkylene)-based ionomers with pendant pentyltrimethylammonium group to improve the swelling resistance and mechanical robustness but without solubility compromise. The copolymers, either bromomethyl terminated precursors or the subsequent alkyltrimethylammonium-tethered ionomers, were readily soluble as the quaterphenylene units controlled to less than 63 mol%, which make the solvent processing possible. Comparison to the poly(bipheylene alkylene)-based analogue, quaterphenylene-containing P(4PA-co-2PA) membranes showed lower water absorption and suppressed swelling. Specifically, at a given ion exchange capacity (IEC) of 2.0 mmol g‒1, quaterphenylene-free P2PA-73 showed the 29 wt% water uptake and 6.1% in-plane swelling at room temperature, while these two values decreased to 9 wt% and 0.6%, respectively, for P(4PA-co-2PA)-63 with 63 mol% of quaterphenylene units. Moreover, P(4PA-co-2PA) membrane also showed good alkaline stability, no detectable degradation was observed after a 1500-h aging in 1 M NaOH at 80 °C, and a 19.3% conductivity loss was recorded after a 720-h treatment in 5 M NaOH at 80 °C. P(4PA-co-2PA) membranes were further assembled to the H2–O2 fuel cell devices, and a 0.4 W cm‒2 peak power density was achieved for the cell prototype assembled from P(4PA-co-2PA)-47 AEM. Moreover, in-situ stability test showed that the P(4PA-co-2PA)-47-based cell can operated stably for 100 h with a low voltage decay rate of 0.82 mV h‒1. Overall, the results of this study provide a simple structural modification strategy that will guide the molecular design of poly(arylene alkylene)-based ionomeric materials with improved membrane properties.

Anion Exchange Membranes with Clusters of Alkyl Ammonium Group for Mitigating Water Swelling but Not Ionic Conductivity

Poly (aryl Ether Ketone)/polymeric Ionic Liquid with Anisotropic Swelling Behavior for Anion Exchange Membranes

Poly(olefin)-Based Anion Exchange Membranes Prepared Using Ziegler–Natta Polymerization

Novel Cross-Linked Anion Exchange Membranes with Diamines As Ionic Exchange Functional Groups and Crosslinking Groups

Diphenylanthracene-based ion exchange membranes with high conductivity and robust chemical stability for acid-alkaline amphoteric water electrolysis

A novel anion exchange membrane based on silicone/polyphenylene oxide with excellent ionic conductivity for AEMFC

Anion Exchange Membrane Crosslinked in the Easiest Way Stands out for Fuel Cells

Towards high conductivity and stability diblock poly(norbornene)s-based anion exchange membranes crosslinked with alkyl quaternary ammonium cationic clusters

Improvement the hydroxide conductivity and alkaline stability simultaneously of anion exchange membranes by changing quaternary ammonium and imidazole contents

Anion exchange membranes with branched ionic clusters for fuel cells

Crosslinked High-Performance Anion Exchange Membranes Based on Poly(styrene-B-(ethylene-co-butylene)-b-styrene)

Hydrophilic Side Chain Assisting Continuous Ion-Conducting Channels for Anion Exchange Membranes

Dimensionally and oxidatively stable anion exchange membranes based on bication cross-linked poly(meta-terphenylene alkylene)s

Comb-shaped anion exchange membrane with segmented hydrophilic/hydrophobic side chain

Highly stable poly(p-quaterphenylene alkylene)-based anion exchange membranes

Macromolecular crosslink of imidazole functionalized poly(vinyl alcohol) and brominated poly(phenylene oxide) for anion exchange membrane with enhanced alkaline stability and ionic conductivity

Poly(biphenyl piperidinium) Anion Exchange Membranes for Alkaline Water Electrolyzers: The Effect of Nonionic Pendant Groups

Multi‐cation side‐chain‐type containing piperidinium group poly(2,6‐dimethyl‐1,4‐phenylene oxide) alkaline anion exchange membranes

Highly Water Resistant Anion Exchange Membrane for Fuel Cells.

Design of pendent imidazolium side chain with flexible ether-containing spacer for alkaline anion exchange membrane

Physically and Chemically Stable Anion Exchange Membranes with Hydrogen-Bond Induced Ion Conducting Channels