Abstract:The low temperature plume exhausted from a cryogenic wind tunnel may sink down, posing a severe threat to public health and safety. Quantitative risk assessment of cryogenic plume flow behavior therefore plays an important role in the design and optimization of a cryogenic wind tunnel. A numerical model with a modified Hertz-Knudsen relation considering the phase change physics of the small quantity of water involved is applied to analyze the dispersion of the low temperature nitrogen plume exhausted from a 0.3 m cryogenic wind tunnel. The homogeneous multiphase flow is modeled using the single-fluid mixture model. A model validation is presented for the exhaust plume from the US National Transonic Facility (NTF). The predicted results are found to be better than those predicted by National Aeronautics and Space Administration (NASA)’s two-stage analytical model. The influences of the environmental wind speed, the environmental wind temperature, the relative humidity, and the exhaust flow rate, on low temperature nitrogen plume dispersion are obtained. In particular, the parametric sensitivities of different influence factors are analyzed. The environmental wind temperature and the exhaust flow rate of the nitrogen gas have greater impact on the temperature of the plume near the ground than do the environmental wind speed and the relative humidity. The exhaust flow rate of the nitrogen gas has greater impact on the oxygen concentration near the ground than does the environmental wind speed, while the environmental wind temperature and the relative humidity have negligible impacts. The results provide guidance on the operation and design improvement of a cryogenic gaseous nitrogen discharge system to avoid its potential hazards.

Computational investigation on nitrogen displacement process in a thermal environment simulation chamber

Numerical investigation on the impact of injection rates on cooling performance in a rotor-stator cavity with liquid nitrogen spraying

A Parametric Sensitivity Study by Numerical Simulations on Plume Dispersion of the Exhaust from a Cryogenic Wind Tunnel

Experimental and Numerical Investigation on Humidity Distribution in an Environmental Chamber

A Computational Fluid Dynamic Study for Temperature Uniformity at a Wind Tunnel Outlet with Effects of Heat Transfer along Tunnel Walls

Collision Dynamics of Two Liquid Nitrogen Droplets under a Low-Temperature Condition

Numerical Analysis of Entrainment Effects on Impingement Heat Transfer at High Temperature Difference

Cooling Performance of Multi-Nozzle Spray with Liquid Nitrogen

Numerical Simulation Studies on Multiphase Flow in High Temperature Wind Tunnel Contractions and Experimental Sections

Study on High-Speed Condensation Heat Transfer of Steam/nitrogen Mixture in Horizontal Rectangular Channel

Numerical investigation on submerged steam jet condensation in subcooled water flow in a restricted channel with the presence of non-condensable gas

Numerical Analysis of Nitrogen Condensation Heat Transfer Enhancement with Liquid Film Fluctuation at Cryogenic Temperature

Numerical Investigation Of Indoor Aerosol Particle Dispersion Under Stratum Ventilation And Under Displacement Ventilation

Effects of initial mist conditions on simulation accuracy of humidity distribution in an environmental chamber

Numerical Simulation and Optimization of the Humidity Field in Environmental Chamber of Test with Electric Equipment

Direct numerical simulation of kinematics and thermophoretic deposition of inhalable particles in turbulent duct flows

Numerical Study of the Effects of Injection Fluctuations on Liquid Nitrogen Spray Cooling

Numerical investigation of transient gas–solid heat transfer in a packed bed: Impact of intra-particle thermal diffusion

Effect of Temperature Boundary Conditions on Micronozzle Performance

Numerical simulation of phase change heat transfer and flow for fin-tube vaporizer

Experimental and Numerical Study on the Heat Transfer Deterioration of Supercritical Nitrogen in a Vertical Tube