Abstract:Electricity generated from renewable energy source fluctuates heavily and can hardly be predicted. The peak shaving (or load cycling) operation of conventional thermal power plants is an effective means to mitigate the mismatch between electricity demands and supplies. Therefore, determining how thermal power plants can operate in a flexible and effective mode is an urgent issue that should be addressed. For thermal power plants, new methods and strategies need to be proposed to face the challenge of the integrating flexibility and energy saving into transient processes. Dynamic performances of thermal power plants during load cycling processes are affected by the coupling of the thermal system and the control system. Feasible approaches from optimizing the coordinated control system (CCS) may radically enhance the peak shaving capacity of thermal power plants. The heat storage in a coal-fired power plant, including heating surface metals and work media, varies with the load rate of the plant. During cycling load operations, the real-time heat storage value of one unit differs from that of the corresponding steady state load command rate. This difference hinders the flexibility of one unit and affects its economic performances during cycling processes. In this paper, a revised water fuel ratio (WFR) control strategy based on heat storage difference was proposed and tested on established coal-fired power plant models. Results show that the accumulation deviations of load rate command and real-time load rate are considerably reduced during load cycling processes when the proposed WFR control strategy is introduced. The revised WFR control strategy diminishes the difference between the target and the actual total power output. When the load cycling rate varies from 10 to 30 MW min(-1) between 50% and 100% THA, the standard coal consumption variation rate (Delta b(s),) decreases by 0.31-1,01 g kW(-1) h(-1) during loading up processes, and decreases by 0.26-1.69 g kW(-1) h-(1) during loading down processes.

Dynamic Modeling and Operation Optimization for the Cold End System of Thermal Power Plants During Transient Processes

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Adaptive Modeling and Operation Optimization for the Cold End System of Thermal Power Units Based on Mechanism and Statistical Analysis

Dynamic simulation and optimization of load change operation of high-temperature gas-cooled reactor pebble-bed module

Pseudo-online Optimization of Condenser Pressure for the Cold-End System with Variable Speed Pumps

Thermodynamic Optimization of the Superheater During Switching the Load Transient Processes

Impact of cold source temperature on transcritical CO 2 power cycle: Design point optimization and off-design performance analysis

Operation Data Based Modelling And Optimization Of Thermal Power Units Under Full Working Conditions

Dynamic Modeling, Validation and Analysis of Direct Air-Cooling Condenser with Integration to the Coal-Fired Power Plant for Flexible Operation

On the Dynamic Modeling and Control of the Cold-End System in a Direct Air-Cooling Generating Unit

Modelling and Optimization of the Direct Air Cooling Power Generation Unit

Peak Shaving Operational Optimization of Supercritical Coal-Fired Power Plants by Revising Control Strategy for Water-Fuel Ratio

Study on Operating Characteristics of Power Plant with Dry and Wet Cooling Systems

Online optimization software development of 600MW steam turbine cold-end based on SIS

OPERATION OPTIMIZATION AND ECONOMIC EFFICIENCY DIAGNOSIS ON COLD END SYSTEM OF 300 MW UNIT IN SHAJIAO A POWER PLANT

Optimization of Cold-End System of Thermal Power Plants Based on Entropy Generation Minimization

Dynamic Performance Comparison of CO2 Mixture Transcritical Power Cycle Systems with Variable Configurations for Engine Waste Heat Recovery

Thermodynamic Analysis on the Transient Cycling of Coal-Fired Power Plants: Simulation Study of a 660 MW Supercritical Unit

Optimization on Coordinate Control Strategy Assisted by High-Pressure Extraction Steam Throttling to Achieve Flexible and Efficient Operation of Thermal Power Plants

Study of Peak-load regulation characteristics of a 1000MWe S-CO 2 Coal-fired power plant and a comprehensive evaluation method for dynamic performance

Study of Peak-load regulation characteristics of a 1000MWe S-CO2 Coal-fired power plant and a comprehensive evaluation method for dynamic performance