Abstract:Abstract Purpose One of the key challenges in the research of phononic crystals is achieving small-size control of large wavelengths, which means obtaining low-frequency band gaps with relatively small lattice dimensions. Previous studies have mostly been unsatisfactory in this regard. To obtain lower starting frequencies and more satisfactory band gap widths, this work presents a novel design for a phononic crystal structure. Design Approach The proposed phononic crystal consists of a silicon rubber connecting plate, an epoxy resin substrate, and tungsten metal cone scatterers. Through finite element method (FEM) calculations and analysis, we have successfully achieved an ultrawide band gap. To delve further into the origin of the ultra-wideband gap in a newly conceived phononic crystal, the vibrational modes of this crystal were carefully studied. Findings This work has successfully achieved an ultrawide band gap with a width ranging from 122.47 to 4360.2 in the case of a lattice constant of a = 8.5 mm. It was found that the low-frequency ultra-wideband gap cannot be obtained without the presence of silicone rubber. Furthermore, an equivalent spring model was developed, and the accuracy of this model was successfully validated through meticulous calculations. At last, It is found that d1, d4, h1, and h3 have the most pronounced effect on the ultrawide bandgap, and the intrinsic reason is the fact that they determine the geometric structure of the silicone rubber connection plate. Research Limitations/implications Due to the chosen research method of finite element analysis, the study results may vary depending on the different mesh discretizations, but this type of error is small and can be ignored. Practical Implications This work provides a new design solution for phononic crystal miniaturization. Originality/value Compared with previous reports, the new phonon crystals designed in this paper have smaller size, lower starting frequency, and wider band gap.

Ultra‐Wide Band Gap in Two‐Dimensional Phononic Crystal with Combined Convex and Concave Holes

Multi-band Design for One-Dimensional Phononic Crystals

Ultrawide phononic band gap for combined in-plane and out-of-plane waves

Study of Band Gaps of Two-Dimensional Phononic Crystals with Criss-Crossed Elliptical Holes

3-D phononic crystals with ultra-wide band gaps

Study on Elastic Wave Band Gap Excitation of Phononic Crystal at Ultra-Low Filling Rate

Large One-Dimensional Band Gaps in Three-Component Phononic Crystals Plates

Ultrawide band gaps in beams with double-leaf acoustic black hole indentations

Topological design of phononic crystals for multiple wide band gaps

Low-Frequency Ultrawide Band Gap Study of Symmetric Conical Scatterer Phononic Crystal

Maximizing acoustic band gap in phononic crystals via topology optimization

Effects of void geometry on two-dimensional monolithic porous phononic crystals

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Design of Phononic-Like Structures and Band Gap Tuning by Concurrent Two-Scale Topology Optimization

Topological design of square lattice structure for broad and multiple band gaps in low-frequency range

Band gaps in phononic crystals: Generation mechanisms and interaction effects

Design of novel two-dimensional single-phase chiral phononic crystal assembly structures and study of bandgap mechanism

Multiple Band Gaps of Phononic Crystals with Quasi-Sierpinski Carpet Unit Cells

On the lowest-frequency bandgap of 1D phononic crystals

Broadening Band Gaps of Bragg Scattering Phononic Crystal With Graded Supercell Configuration

Band structures of two dimensional solid/air hierarchical phononic crystals