Abstract:Currently, liquid-to-gas heat exchangers in buildings, domestic appliances and the automotive industry are mainly made of copper and aluminum. Using plastic instead of metal can be very beneficial from an economic and environmental point of view. However, it is required that a successful plastic design meets all the requirements of metal heat exchangers. The polymeric hollow fiber heat exchanger studied in this work is completive to common metal finned heat exchangers. Due to its unique design (the use of thousands of thin-walled microtubes connected in parallel), it achieves a high level of compactness and thermal performance, low pressure drops and high operation pressure. This paper focuses on an important aspect of heat exchanger operation—its fouling in conditions relevant to building and domestic application. In heating, ventilation and air conditioning (HVAC) and automotive and domestic appliances, outdoor and domestic dust are the main source of fouling. In this study, a heat exchanger made of polymeric hollow fibers was tested in conditions typical for indoor HVAC equipment, namely with the 20 °C room air flowing through the hot water coil (water inlet 50 °C) with air velocity of 1.5 m/s. ASHRAE test dust was used as a foulant to model domestic dust. A polymeric heat exchanger with fibers with an outer diameter of 0.6 mm (1960 fibers arranged into 14 layers in total) and a heat transfer area of 0.89 m2 was tested. It was proven that the smooth polypropylene surface of hollow fibers has a favorable antifouling characteristic. Fouling evolution on the metallic heat transfer surfaces of a similar surface density was about twice as quick as on the plastic one. The experimental results on the plastic heat exchanger showed a 38% decrease in the heat transfer rate and a 91% increase in pressure drops after eighteen days of the experiment when a total of 4000 g/m2 of the test dust had been injected into the air duct. The decrease in the heat transfer rate of the heat exchanger was influenced mainly by clogging in the frontal area because the first layers were fouled significantly more than the deeper layers.

Heat‐transfer Characteristics of Polymer Hollow Fiber Heat Exchanger for Vaporization Application

Experimental research on flow resistance and heat transfer characteristics of polymer helical coils heat exchanger

Numerical Study on Hydrodynamics, Mixing and Heat Transfer of Highly Viscous Fluid in a Novel Shell-and-tube Heat Exchanger with X-type Baffles

Improvement of Thermal Performance of Novel Heat Exchanger with Latent Heat Storage

Hollow fiber polytetrafluoroethylene membrane heat exchanger with anti-corrosi properties

Experimental determination of the heat transfer coefficients of shell-and-tube heat exchangers with different hollow fiber arrangements

Experimental And Numerical Analyses On The Poly(Lactide-Co-Glycolide) Hollow Fiber Membranes

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Heat transfer analysis of carbon fiber-reinforced corrugated polymer plate heat exchangers

Crossflow polymeric hollow fiber heat exchanger: fiber tension effects on heat transfer and airside pressure drop

Numerical study on heat transfer performance of printed circuit heat exchanger with anisotropic thermal conductivity

Physicochemical Characteristics of Hollow Fiber Structured Packings in Isopropanol/Water Distillation

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Additively manufactured polymer composites for heat exchanger applications: evaluation of critical thermophysical properties

Expanded microchannel heat exchanger: design, fabrication and preliminary experimental test

Experimental investigation of plastic finned-tube heat exchangers, with emphasis on material thermal conductivity

Fouling of Polymeric Hollow Fiber Heat Exchangers by Air Dust

Thermal conductivity of polymers and polymer nanocomposites

Thermal performance analysis of heat pipe heat exchanger for effective waste heat recovery

Multi-factor analysis on thermal conductive property of metal-polymer composite microstructure heat exchanger

Experimental Investigation on the Thermal Performance of Pulsating Heat Pipe Heat Exchangers