Abstract:About 10wt.% of glycerol can be produced during the conversion of vegetable oils or animal fats into biodiesel fuel by the transesterification process. To make use of glycerol and increase its values, H2 production from catalytic steam reforming of glycerol by Ni–Mg–Al based catalysts was evaluated experimentally in a fixed-bed reactor under atmospheric pressure within a temperature range of 450–650°C. The thermodynamic analysis was conducted by using a non-stoichiometric methodology based on the minimization of Gibbs free energy. The Ni–Mg–Al based catalysts were synthesized by the co-precipitation method with rising pH technique. The synthesized catalysts were characterized by the elemental analysis, BET, XRD and SEM methods. All the metals in the catalyst remained in oxide forms and the catalysts had the specific surface areas from 98.542 to 126.777m2/g for different compositions. The results showed that glycerol conversion and H2 selectivity were increased with increasing temperatures from 450 to 650°C. The formations of CH4 and CO in the glycerol steam reforming were almost negligible. Carbon formation in glycerol steam reforming was serious in low temperatures. The catalyst containing NiO of 24.1wt.%, MgO of 26.1wt.% and Al2O3 of 49.8wt.% performed appreciable catalytic activity, and the H2 selectivity was found to be 78.5% and conversion of glycerol was up to 88.0% at 650°C. The effects of the operating conditions including temperature, the ratio of steam to carbon (S/C), glycerol inlet concentration and flow rate of carrier gas on glycerol steam reforming by the optimized catalyst were tested. Based on a kinetic model assuming the power law with a first reaction order, the activation energy and the frequency factor for glycerol steam reforming by the Ni–Mg–Al based catalysts were calculated.

Hydrogen Production by Glycerol Reforming in a Fixed-Bed Reactor

Hydrogen production by glycerol reforming in a two-fixed-bed reactor

Hydrogen production from glycerol steam reforming over Ni/La/Co/Al2O3 catalyst

Improved Hydrogen Production by Glycerol Photoreforming over Ag2O-TiO2 Nanocomposite Mixed Oxide Synthesized by a Sol-gel Method

Preparation Of Syngas By Reforming Of Biological Glycerol On Charcoal Catalyst

Hydrogen production from steam reforming of glycerol by Ni–Mg–Al based catalysts in a fixed-bed reactor

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Hydrogen Production from Glycerol Steam Reforming over Monolithic Catalyst

Hydrogen Production from Glycerol by Supercritical Water Gasification in a Continuous Flow Tubular Reactor

Hydrogen Production by Catalytic Steam Reforming of Heavy Components in Bio-Oil in Fluidized Bed Reactor

Hydrogen Production Through Catalytic Steam Reforming of Simulacrum of Light Component of Bio-Oil in a Fluidized Bed Reactor

Renewable hydrogen production from steam reforming of glycerol by Ni–Cu–Al, Ni–Cu–Mg, Ni–Mg catalysts

Hydrogen Production from the Aqueous Phase Derived from Fast Pyrolysis of Biomass

Hydrogen Production from Aqueous Phase Reforming of Glycerol: Thermodynamic Analysis and Experimental Validation

Hydrogen Production Via Catalytic Steam Reforming of Fast Pyrolysis Bio-oil in a Fluidized-Bed Reactor

STEAM REFORMING BIO-OIL TO PRODUCE HYDROGEN IN A FLUIDIZED BED REACTOR

Hydrogen Production by Biomass Gasification at Low Temperature and Catalytic Reforming of the Volatile

Catalytic Steam Reforming of Fast Pyrolysis Bio‐Oil in Fixed Bed and Fluidized Bed Reactors

Hydrogen Production by Catalytic Steam Reforming of Model Compounds of Bio-Oil

Potential of Hydrogen Production from Biomass

Hydrogen Production from Bio-Char Via Steam Gasification in A Fluidized-Bed Reactor