Experimental investigation on transient boiling heat transfer during quenching of fuel cladding surfaces
Jinbiao Xiong,Zefeng Wang,Ping Xiong,Tao Lu,Yanhua Yang
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2019.119131
IF: 5.2
2020-01-01
International Journal of Heat and Mass Transfer
Abstract:In case of postulated accidents in a nuclear reactor, the fuel rods uncovered from coolant can be overheated. Immediate quenching of overheated fuel rods is desired. Quenching experiment is performed at atmospheric pressure with rodlets of the FeCrAl alloy, one of the accident tolerant fuel cladding materials, and the Zircaloy-4, the conventional cladding material. In the experiment 600 degrees C rodlet specimens are plunged into the subcooled water bath. A high-speed camera is employed to record quenching phenomenon. With the embedded thermocouples the rodlet temperature is measured at the frequency of 50 Hz. One-dimensional inverse heat conduction problem is solved to obtain the surface temperature and heat flux. Influence of surface condition, solid thermal properties and liquid subcooling on transient boiling heat transfer is investigated. In the film boiling regime heat transfer is mainly affected by solid thermal properties and liquid subcooling. Small solid (k rho C-p)(w) and large liquid subcooling results in relatively thin vapor film and more efficient film boiling heat transfer. Roughness on the polished level shows no appreciable influence on the minimum film boiling temperature, T-MFB, which increases with decreasing contact angle. Surface oxidation is slow on the FeCrAI surface and hence, does not significantly affect the boiling heat transfer. However, on the Zircaloy-4 surface the oxide layer with small (rho kC(p))(w) increases T-MFB and decreases the critical heat flux. Large (rho C-p)(w), results in slow quench front propagation, long quench duration and weak subcooling effect. It is found that on each surface the vapor film collapses at the critical thickness which is irrelevant to liquid subcooling. Based on the critical thickness, a new approach for prediction of T-MFB is proposed. (C) 2019 Elsevier Ltd. All rights reserved.