Abstract:Torrefaction is a promising technology to scale up the utilization of biomass for power purposes. The ash-related issues during biomass combustion and co-combustion are essential to be addressed, however, on which the effects of torrefaction are seldom concerned and need in-depth and comprehensive investigation. To provide useful information related, the authors conducted a series of studies. In the present work, the particulate matter (PM) emission during combustion is focused on. Three biomasses were torrefied at a fixed-bed reactor, and the elemental release and transformation during torrefaction were characterized through chemical fractionation analysis. The combustion tests of the raw and torrefied biomass and their blends with two typical coals were conducted on a drop-tube furnace at 1300°C in air. The PM 10 (particulate matter with an aerodynamic particle size below 10 μm) collected by a Dekati low-pressure impactor and PM 10+ (particulate matter with an aerodynamic particle size above 10 μm) collected by a Dekati cyclone were characterized by a scanning electron microscope equipped with energy dispersive spectrometer (SEM-EDS). The results indicate that torrefaction effectively reduces S and Cl in biomass while slightly reducing the alkalis. The contents of refractory elements (Mg, Ca, and Fe) are hardly influenced. Torrefaction promotes the transformation of AAEMs (alkaline and alkaline earth metals) into less-reactive forms (HCl-soluble and insoluble). The vaporization of alkalis, S, and Cl during biomass combustion is reduced and the retention of AAEMs into aluminosilicates is promoted after torrefaction. This reduces the emission of PM 1 (particulate matter with an aerodynamic particle size below 1 μm) from biomass combustion. During co-combustion, the PM emission largely depends on the combined effects of elemental vaporization, competing reactions (alkalis against Mg, Ca, and Fe), retention of metals into aluminosilicates, and sulfation of chlorides. The inhibited effect of torrefaction on mineral vaporization reduces the formation of PM 1 by condensation. The emission of PM 1-10 (particulate matter with an aerodynamic particle size between 1 and 10 μm) either increases due to the promoted retention of the metals in coarse particles or decreases by agglomerating into PM 10+ . Torrefaction shows a preferable performance concerning its effects on PM emission during biomass combustion and co-combustion with coal.

Aggravated fine particulate matter emissions from heating-upgraded biomass and biochar combustion: The effect of pretreatment temperature

Ultrafine Particle Formation in Pulverized Coal, Biomass, and Waste Combustion: Understanding the Relationship with Flame Synthesis Process

Emission Behaviors of Submicron Particles (PM1) Generated by the Combustion of Sesame Stalk after Combined Water Washing and Carbonization Pretreatment

Performance Evaluation of Biomass Pretreated by Demineralization and Torrefaction for Ash Deposition and PM Emissions in the Combustion Experiments

Gas Emissions from Blends of Bituminous Coal and Biomass Chars under Different Pyrolysis Conditions

The Effect of Preheating Temperature and Combustion Temperature on the Formation Characteristics of PM0.4 from Preheating Combustion of High-Alkali Lignite

Effects of torrefaction on ash-related issues during biomass combustion and co-combustion with coal. Part 1: Elemental partitioning and particulate matter emission

Impact of Dilution Ratio and Burning Conditions on the Number Size Distribution and Size-Dependent Mixing State of Primary Particles from Domestic Solid Fuel Burning

Particulate Matter Emission and K/S/Cl Transformation During Biomass Combustion in an Entrained Flow Reactor

Experimental and DFT Research on the Effects of O2/CO2 and O2/H2O Pretreatments on the Combustion Characteristics of Char

Synergistical reduction of PM and NO formation in preheating co-firing of coal and biomass

Effects of Preheating Temperature, O2 Distribution Concentration and Combustion Temperature on the Formation of PM During Preheating-Low NO Combustion

Synergistic reduction on PM and NO source emissions during preheating-combustion of pulverized coal

Effects of preheating temperature, O 2 distribution concentration and combustion temperature on the formation of PM during preheating-low NO combustion

Effect of Torrefaction on Rice Straw Physicochemical Characteristics and Particulate Matter Emission Behavior During Combustion

Pyrolysis Pretreatment of Biomass for Entrained-Flow Gasification

Investigation on PM Formation from Combustion of Lignite with High Contents of AAEMs (alkali and Alkaline Earth Metals) and Fe: Effect of the Reaction Temperature

Effects Of Fgr And Changeable Combustion Parameters And Coal/Char Properties On The Formation Of Ultrafine Pms During Pulverized Coal Char Combustion Under Various O-2/N-2 And O-2/Co2 Atmospheres

Effect of Pyrolysis Upgrading Temperature on Particulate Matter Emissions from Lignite Semi-Char Combustion

Effects of fuel elemental composition and combustion temperature on PM 10 formation behaviors from combustion of municipal solid waste and refuse-derived fuel

Catalytic Control of Typical Particulate Matters and Volatile Organic Compounds Emissions from Simulated Biomass Burning