Abstract:Robotic wire and arc additive manufacturing (WAAM) systems are required to provide predictable and efficient operations to fabricate solid metallic parts with high morphological fidelity and geometric accuracy. Since the metallic parts are fabricated based on a layer-by-layer principle, the interactions between the neighboring beads and layers strongly influence the geometric accuracy of the fabricated part. The layers-overlapping process has been studied and a traditional layers-overlapping model (T-LOM) has been published in the literature. This paper proposes a layers-overlapping strategy (LOS), based on which a revised layers-overlapping model (R-LOM) was proposed for the fabrication of multi-layer multi-bead (MLMB) components with homogeneous layers. A mathematical model for layers-overlapping is presented, which considers the material shortage areas at the edges of the layers. This is important since the material shortage areas result in a situation that the component width is smaller than the expected value. In addition, they will be accumulated when multiple layers are overlapped through normal unidirectional parallel (NUP) paths. The proposed LOS addresses two aspects: (i) the deposition amount of the first bead and the last bead in the lap layers should be increased and (ii) the deposition position of the first bead and the last bead in the lap layers should be moved towards the edges with a given offset distance. Validation experiments were designed and conducted to test the proposed concepts and models. The experimental results indicated that (i) the R-LOM enables the MLMB components to achieve the expected width and (ii) for components deposited with NUP paths, the R-LOM eliminates the effect of accumulation of material shortage areas on the first bead and increases the surface flatness.

Enhanced Beads Overlapping Model for Wire and Arc Additive Manufacturing of Multi-Layer Multi-Bead Metallic Parts

A multi-bead overlapping model for robotic wire and arc additive manufacturing (WAAM)

The gap-filling overlapping model for wire and arc additive manufacturing of multi-bead components

Bead Modelling and Implementation of Adaptive MAT Path in Wire and Arc Additive Manufacturing

Generalised overlapping model for multi-material wire arc additive manufacturing (WAAM)

A Layers-Overlapping Strategy for Robotic Wire and Arc Additive Manufacturing of Multi-Layer Multi-Bead Components with Homogeneous Layers

An Innovative Finite Element Geometric Modeling of Single-Layer Multi-Bead WAAMed Part

A layer superposition strategy based on a theoretical model for wire and arc additive manufacturing of multi-layer single-bead components

A Nonautoregressive Dynamic Model Based Welding Parameter Planning Method for Varying Geometry Beads in WAAM

A Model of Bead Size Based on the Dynamic Response of CMT-based Wire and Arc Additive Manufacturing Process Parameters

Online Control of Deposited Geometry of Multi-layer Multi-bead Structure for Wire and Arc Additive Manufacturing

Effect of auxiliary longitudinal magnetic field on overlapping deposition of wire arc additive manufacturing

Model of weld beads geometry produced on surface temperatures by Wire and Arc Additive Manufacturing (WAAM)

Bead Modelling and Deposition Path Planning in Wire Arc Additive Manufacturing of Three Dimensional Parts

Experimental and Numerical Investigation of Double Pass Overlapping Beads by Twin-Wire Welding Additive Manufacturing Process

Bead Geometry Prediction for Multi-layer and Multi-bead Wire and Arc Additive Manufacturing Based on XGBoost

Modeling of bead section profile and overlapping beads with experimental validation for robotic GMAW-based rapid manufacturing

A Net Shape Profile Extraction Approach for Exploring the Forming Appearance of Inclined Thick-Walled Structures by Wire Arc Additive Manufacturing

Interlayer Closed-Loop Control of Forming Geometries for Wire and Arc Additive Manufacturing Based on Fuzzy-Logic Inference

Research on Support-Free WAAM Based on Surface/interior Separation and Surface Segmentation

Prediction of bead geometry with consideration of interlayer temperature effect for CMT-based wire-arc additive manufacturing