Abstract:Permanent magnet vernier machines (PMVMs) exhibit the feature of high torque density, which makes them a compelling candidate for gearless direct-drive applications, such as electric vehicle (EV) and servo drive. However, the motor suffers from low power factor issue. And the long end winding, caused by overlaps and long spanning distance, significantly reduces the efficiency and torque density for motors with small size and short stack length. This paper investigates the performance metrics of PMVMs with surface Halbach magnet array for different slot/pole combinations (gear ratios) and winding layouts (short-pitch, fractional-slot). It is found that the fractional-slot winding creates more possibility for vernier machines. First, the working principle of vernier machines is analyzed and the performance metrics are modeled with analytical approach. Then, the motor configuration is classified according to winding layout and some promising structures are selected. Later, a comprehensive comparison is conducted for selected candidates in all electromagnetic performance by using finite element analysis (FEA). The results show that the vernier motors with fractionalslot winding layout and non-integer gear ratios can achieve much lower torque ripple, and higher power factor than integral-slot winding, while sacrifising a little active torque density. Designs with smaller gear ratios can achieve higher efficiency due to short end winding. These findings can provide design guidelines for high-performance PMVMs.

Comparative study of double-sided toroidal-winding linear PM vernier machines with different secondary configurations

Comparison of Dual-Stator Permanent Magnet Machines with Different Rotor Topologies

Comparison of Optimal Design and Performance of PM Machines Having Non-Overlapping Windings and Different Rotor Topologies

Comparative Study of Novel Doubly Fed Doubly Salient PM Machines with Different Stator/Rotor-Pole Number Combinations

Influence of Split Teeth on the Performance of Linear Permanent Magnet Vernier Motor

Comparison Between Dual-Armature Linear Switched Flux Permanent Magnet Machine and Linear Surface-Mounted Permanent Magnet Machine Considering Thermal Conditions

Analytical On-Load Subdomain Field Model of Permanent-Magnet Vernier Machines.

Comparison of Toroidal-Winding Linear PM Vernier Machines with Typical Linear Synchronous Machines in Aspect of Thrust Force Characteristics

Comparison of Vernier Machines with Different Rotor PM Configurations

Analysis of Dual PM Vernier Machines with Different Consequent-Pole PM Topologies

Comparative Investigation Of Single-Sided And Double-Sided Permanent Magnet Linear Motor

Comparative Analysis of Doubly Fed Flux-Reversal Permanent Magnet Machines with Different PM Arrangements and Consequent-Pole Topologies

Torque Characteristics Comparison And Analysis Of Surface-Mounted Permanent Magnet Vernier Machines With Different Stator Topologies

Design Considerations, Analysis and Comparison for High-performance Surface Permanent Magnet Vernier Machines

Design of a Chamfered Structure on Consequent-Pole Vernier Permanent-Magnet Machine

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Comparative Study of Double-Stator Interior-PM Vernier Machines Based on Electromagnetic-Structural Coupling Analysis

Comparisons of Torque Performance in Surface-Mounted PM Vernier Machines with Different Stator Tooth Topologies

Research on the Influence of End Turn Length on Consequent-Pole Vernier Permanent-Magnet Machines

Comparative Study of Novel Doubly-Fed Linear Switched Flux Permanent Magnet Machines with Different Primary Structures

Comparative Study of Stator Vernier PM Machines with Different PM Arrangements