Influence of CO 2 injection on characterization of microscopic pore throat structure in shale reservoirs
Xing Huang,Zhiyuan Wang,Mengqing He,Ke Wu,Longlong Chen,Xiongdi Zuo,Le Xue,Shaoqing Liu,Wenlong Hou,Xiang Li,Yiwen Wang,Jun Lu
DOI: https://doi.org/10.1016/j.fuel.2024.133578
IF: 7.4
2024-11-09
Fuel
Abstract:CO 2 injection to displace oil in shale reservoirs will form asphaltene precipitation and harm the microscopic pore-throat structure, influencing the displacement efficiency. However, asphaltene deposition harmed reservoir characteristics and the damage mechanism to microscopic pore-throat structure is not clear. In this study, on the basis of CO 2 displacement experiments, nuclear magnetic resonance (NMR) scanning and low-temperature nitrogen adsorption (LTNA) experiments were used to investigate the damage characteristics of asphaltene deposition on physical properties, wettability, oil recovery and micro-structure of three types of reservoirs under different injection pressures, and reveal the microscopic damage mechanism of asphaltene precipitation on the pore-throat structure. The results show that after CO 2 displacement, the permeability and porosity damage rate is positively correlated with injection pressure, the maximum damage rate is 45.84 % and 42.73 %, respectively. And the asphaltene precipitation results in wettability reversal of pore throats. In addition, the blockage rate of nano-scale pore throats in the three types of reservoirs is higher, with the highest blockage rates of 45.43 %, 52.41 % and 76.45 %, respectively. The worse the reservoir physical properties, the higher the pore throat blockage rate, and the greater damage to the micro-structure by asphaltene precipitation. The amplitude of the LTNA adsorption–desorption curves all decreased, and the adsorption amount of the core samples decreases. The contribution of micropore specific surface area of Type I and II reservoirs decreases, while the contribution of Type III reservoir increases up to 90.76 %. Asphaltene precipitation resulting in a decrease in total pore volume. Asphaltene particles are adsorbed on the pore surface, and the pore diameter decreases with the maximum decrease of 3.36%. The contribution of macropores to the total pore volume and specific surface area is significantly reduced compared to that of micropores and mesopores.
energy & fuels,engineering, chemical