Abstract:Metal–organic framework (MOF) materials have shown promise in many applications, ranging from gas storage to absorption and catalysis. Because of the high porosity and low density of many MOFs, densification methods such as pelletization and extrusion are needed for practical use and for commercialization of MOF materials. Therefore, it is important to elucidate the mechanical properties of MOFs and to develop methods of further enhancing their mechanical strength. Here, we demonstrate the influence of phase purity and the presence of a pore-reinforcing component on elastic modulus and yield stress of NU-1000 MOFs through nanoindentation methods and finite element simulation. Three types of NU-1000 single crystals were compared: phase-pure NU-1000 prepared with biphenyl-4-carboxylic acid as a modulator (NU-1000-bip), NU-1000 prepared with benzoic acid as a modulator (NU-1000-ben), which results in an additional, denser impurity phase of NU-901, and NU-1000-bip whose mesopores were infiltrated with silica (SiOx(OH)y@NU-1000) by nanocasting methods. By maintaining phase purity and minimizing defects, the elastic modulus could be enhanced by nearly an order of magnitude: phase-pure NU-1000-bip crystals exhibited an elastic modulus of 21 GPa, whereas the value for NU-1000-ben crystals was only 3 GPa. The introduction of silica into the mesopores of NU-1000-bip did not strongly affect the measured elastic modulus (19 GPa) but significantly increased the load at failure from 2000 μN to 3000–4000 μN.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c12877?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c12877</a>.SEM images, mechanical data, N2 sorption, XRD, TGA, NMR, and XRD data, atomic ratios from SEM–EDS data, and elemental mapping by STEM-EDS (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c12877/suppl_file/am0c12877_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

PCN-250 under Pressure: Sequential Phase Transformation and the Implications for MOF Densification

Computational Study on Adsorption and Separation of H2/CH4/CO2 in Double-Walled Metal-Dipyrazole Frameworks

Impacts of Functional Group Substitution and Pressure on the Thermal Conductivity of ZIF-8

Phase Transformations in MOFs Induced by Adsorbate Exchange

Survival of Zirconium-Based Metal-Organic Framework Crystallinity at Extreme Pressures

Development of a Mixed Multinuclear Cluster Strategy in Metal-Organic Frameworks for Methane Purification and Storage

Multilevel screening of computation‐ready, experimental metal‐organic frameworks for natural gas purification

Effects of Phase Purity and Pore Reinforcement on Mechanical Behavior of NU-1000 and Silica-Infiltrated NU-1000 Metal–Organic Frameworks

Incorporating Heavy Alkanes in Metal-Organic Frameworks for Optimizing Adsorbed Natural Gas Capacity

Control over interpenetration for boosting methane storage capacity in metal–organic frameworks

Tuning porosity in macroscopic monolithic metal-organic frameworks for exceptional natural gas storage

Unveiling Non-Monotonic Deformation of Flexible MOFs during Gas Adsorption: From Contraction and Softening to Expansion and Hardening

Creating Optimal Pockets in a Clathrochelate-Based Metal–Organic Framework for Gas Adsorption and Separation: Experimental and Computational Studies

Pressure effects on metal/covalent-organic frameworks: structural and optical properties

The elasticity of MOFs under mechanical pressure

Tracking CO2 capture and separation over N2 in a flexible metal–organic framework: insights from GCMC and DFT simulations

Densification and shaping of pure Cu-BTC powders using a solid-state chemical transformation.

Methane Storage and Purification of Natural Gas in Metal‐Organic Frameworks

Transient Catenation In A Zirconium-Based Metal-Organic Framework And Its Effect On Mechanical Stability And Sorption Properties

An investigation of CO2 conversion capacity for PCN series doped with different 3d ions (Fe2+, Co2+ and Cu2+)

Unusual Moisture-Enhanced CO2 Capture within Microporous PCN-250 Frameworks