Abstract:This paper presents a two-step deterministic approach for identifying an unknown point source with a constant emission rate in built-up urban areas. The analytic form of the marginal posterior probability density function of the source location is derived to estimate the source location. The emission rate is then estimated using the conditional posterior distribution. Such a procedure deconstructs the calculation of the joint posterior distribution of the source parameters into calculations of two separate distributions and can thus be easily calculated directly and accurately without stochastic sampling. The proposed method is tested using real data obtained in two wind tunnel scenarios of contaminant dispersion in typical urban geometries represented by block arrays. Computational fluid dynamics (CFD) modeling and the adjoint equations are used to calculate the building-resolving source-receptor relationship required in the identification. The estimated source parameters in both cases are close to true values. In both cases, the source locations are identified with errors less than half of the block size, and the emission rates are well estimated, with only slight overestimation. Moreover, in this paper, we test two potential performance indicators for a posteriori evaluation of the credibility of a certain estimation. One indicator is the size of the highest probability density region, and the other is the angle between the observed and predicted concentration vectors, which is derived from the analytic form of the marginal posterior distribution of the source location. Synthetic concentration data are generated to test the validity of both indicators. It is found that the former is not appropriate for denoting the credibility of estimations but that the latter shows a strong correlation with estimation performance and is likely to be an effective performance indicator for Bayesian source term estimation.

Turbulent Schmidt Number for Source Term Estimation Using Bayesian Inference

Source term estimation with deficient sensors: Traceability and an equivalent source approach

Source term estimation with deficient sensors: A temporal augment approach

Source term estimation for continuous plume dispersion in Fusion Field Trial-07: Bayesian inference probability adjoint inverse method

Bayesian Identification of a Single Tracer Source in an Urban-Like Environment Using a Deterministic Approach

An inverse method to estimate emission rates based on nonlinear least-squares-based ensemble four-dimensional variational data assimilation with local air concentration measurements

Bayesian Source Term Estimation of Atmospheric Releases in Urban Areas Using LES Approach.

The impact of sensor layout on Source Term Estimation in urban neighborhood

Identification of Pollution Sources in Urban Wind Environments Using the Regularized Residual Method

Federated learning based atmospheric source term estimation in urban environments

Dynamical Source Term Estimation in a Multi-Compartment Building under Time-Varying Airflow

Identification of Parameters for Standard K-Ε Turbulence Model Based on Bayesian Inference

Application of Bayesian Inference to Estimate the Parameters in 2D Convection-diffusion Equation with Source

A Sparse Grid Based Bayesian Method for Contaminant Source Identification

Source term estimation of natural gas leakage in utility tunnel by combining CFD and Bayesian inference method

Source term estimation with deficient sensors: Error analysis and mobile station route design

Identification for Schmidt Number in Scalar Transport Process of Turbulent Flows

Source identification for unsteady atmospheric dispersion of hazardous materials using Markov Chain Monte Carlo method

Turbulent Schmidt Number Measurements Over Three-Dimensional Cubic Arrays

Bayesian Inversion of Inflow Direction and Speed in Urban Dispersion Simulations

Sensor Layout Strategy for Source Term Estimation of External Pollution Sources in Urban Neighbourhoods