Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Capacitive Properties of the Binder‐Free Electrode Prepared from Carbon Derived from Cotton and Reduced Graphene Oxide

Facile preparation of binder–free electrode for electrochemical capacitors based on reduced graphene oxide composite film

Facile synthesis of morphology-controllable NiCo<sub>2</sub>S<sub>4</sub> arrays on activated carbon textile as high-performance binder-free supercapacitor electrode

Preparation and Characterization of Free-Standing Electrode Materials from Waste Cotton Fabrics for Electric Double-Layer Capacitors

Composite Organogels of Graphene and Activated Carbon for Electrochemical Capacitors

Highly Porous Reduced Graphene Oxide-Coated Carbonized Cotton Fibers as Supercapacitor Electrodes

Biomass-Derived Carbon Fiber Aerogel As a Binder-Free Electrode for High-Rate Supercapacitors

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

Reduced Graphene Oxide as a Monolithic Multifunctional Conductive Binder for Activated Carbon Supercapacitors

High-Performance and Flexible Electrochemical Capacitors Based on Graphene/Polymer Composite Films

Multiwalled Carbon Nanotubes/Polypyrrole/Graphene/Nonwoven Fabric Composites Used As Electrodes of Electrochemical Capacitor

Selective laser carving-induced patterned electrodes for high-performance binder-free and substrate-free all-carbon-based micro-supercapacitors

Fabrication of a supporting kapok‐carbon/rGO electrode via self-assembly with enhanced capacitance

Cellulose non-woven fabric-derived porous carbon films as binder-free electrodes for supercapacitors

Free-standing carbon network with enhanced capacitive performance synthesized via green H 2 O 2 activation

Economical preparation of high-performance activated carbon fiber papers as self-supporting supercapacitor electrodes

Flexible and porous Co3O4-carbon nanofibers as binder-free electrodes for supercapacitors

Binder-Free Flexible Chickpea Pod Derived Activated Carbon-Carbon Nanofiber Composite for Supercapacitor Application

Porous Cotton-derived Carbon: Synthesis, Microstructure and Supercapacitive Performance

Graphene aerogel with excellent property prepared by doping activated carbon and CNF for free-binder supercapacitor

Controllable Synthesis of 3D Binary Nickel–cobalt Hydroxide/graphene/nickel Foam As a Binder-Free Electrode for High-Performance Supercapacitors