Fabrication of G-C3n4/sio2-au Composite Nanofibers with Enhanced Visible Photocatalytic Activity

Xuejiao Zhou,Ge Zhang,Changlu Shao,Xinghua Li,Xi Jiang,Yichun Liu
DOI: https://doi.org/10.1016/j.ceramint.2017.08.130
IF: 5.532
2017-01-01
Ceramics International
Abstract:Graphitic carbon nitride (g-C3N4) based ternary composite photocatalyst (g-C3N4/SiO2-Au NFs) was prepared using Au nanoparticles (NPs) decorated SiO2 nanofibers (SiO2-Au NFs) as a support by employing a heat treatment with a mixture of urea powder and SiO2-Au NFs. The resulting Au NPs with the mean diameter of about 13 nm were evenly dispersed on the g-C3N4/SiO2-Au NFs. In addition, the thin g-C3N4 nano-layers were found to be uniformly grown on the g-C3N4/SiO2-Au NFs as determined by electron microscopy and elemental mapping image analyses. Comparative studies revealed that the g-C3N4/SiO2-Au NFs showed better photo catalytic activity for the degradation of Rhodamine B (RhB) under visible light than g-C3N4/SiO2 NFs, which was prepared by the same process. The photocurrent enhancement of the g-C3N4/SiO2-Au NFs also indicated an enhanced separation of photo-induced electron-hole pairs. In addition, both the g-C3N4/SiO2-Au and g-C3N4/SiO2 NFs could be easily precipitated and separated, which resulted from their ultra-long one-dimensional nanostructure. Also, the g-C3N4/SiO2-Au NFs exhibited high stability could be reused with little loss of photocatalytic activity after three recycles.
What problem does this paper attempt to address?