Abstract:Evolution of nickel, manganese, and cobalt hydroxide precursor, Ni 1/3 Mn 1/3 Co 1/3 (OH) 2 , in typical co-precipitation reactions is investigated at different pH levels (i.e. 10.6 and 11.4). The growth of the Ni 1/3 Mn 1/3 Co 1/3 (OH) 2 primary and secondary particle is monitored and their particle size distribution revealed different numbers of growth stages for samples prepared at pH 10.6 and pH 11.4. Experimental The experiment is carried out in a 1L CSTR with water bath jacket (60 o C) to synthesize Ni 1/3 Mn 1/3 Co 1/3 (OH) 2 . The reaction proceeds with the addition of 5.0 M NH 3 (aq) at 15 mL/h and 2.0 M MSO 4 (M = Ni, Co, and/or Mn in desired ratios) at 20 mL/h.(1) A pH meter with feedback to the pump is used to monitor the pH value, and 4.0 M NaOH solution is automatically added to the reaction contents by the pump to maintain the desired pH. Samples are prepared with two solution pH levels of 10.6 and 11.4. An overhead rotator is used to stir the solution, and nitrogen gas continuously bubbled into the solution throughout the synthesis. Sample synthesized in the pH 10.6 solution is referred as sample A, while the one synthesized at the high pH level of 11.4 is referred as sample B. The total reaction time is 3 hrs. Ex-situ samples are drawn from the reactor with pipette during the reaction at certain timer intervals. These samples are immediately diluted in vials to avoid further co-precipitation reaction before characterizing their particle size distribution using particle size analyzer (Cilas 1190LD, Cilas Particle Size). Results and Discussion Our analysis focuses on the growth kinetics of the hydroxide primary and secondary particles. Figure 1 (black-square line) shows the change in the median particle size of sample A as a function of reaction time. The secondary particle grows from 1.5 to 16 μm in 3 hours. Three stages of particle growth could be observed: (I) growth and agglomeration of primary particles (before 45 mins); (II) mixed stage (45~100 mins); and (III) surface smoothing of secondary particles (after 100 mins). In stage I, primary particles are formed through instant nucleation, growth, and agglomeration after the addition of transition metal sources. The growth rate is as high as 11.0 μm/h, which is due to the immediate agglomeration of newly formed primary particles, decreasing their surface energy. In contrast, the growth rate of the particles dropped significantly to 0.9 μm/h in stage III. During this stage, the newly added transition metal ions form smooth layers in the void space of the secondary particles surfaces, which consists of disordered nanoplates. This could be proven by the SEM images (not shown here). In stage II, the growth rate of the secondary particles is about 3.2 μm/h, representing a mixed effect of stage I and stage III. This suggests that the growth and agglomeration of the primary particles as well as the surface smoothing of the secondary particles occur at the same time. The change in the growth mechanism is directly related to the concentration of total transition metal ions and hydroxide in the reactor. A quick calculation shows the concentration of transition metal is 0.05 M and 0.1 M at the first turning point (1 hour) and second turning point (2 hour), respectively. Also shown in Figure 1 (red-circle line) is the change in the secondary particle size as a function of reaction time for sample B synthesized at pH 11.4. In this case, the secondary particles grow from 1.5 to 8 μm in 3 hours. Unlike sample A, only two stages of particle growth can be observed: (I) growth and agglomeration of primary particle at 5.1 μm/h for reaction time smaller than 40 mins; and (II) surface smoothing of the secondary particles at 0.9 μm/h for longer reaction time. The lack of the mixed stage in sample B indicates the primary particle agglomeration is not taking place on the formed secondary particles after 40 mins. This observation is also supported by the SEM images.. The concentration of transition metal in the reactor at the turning point (i.e. 40 mins) is about 0.03 M. A. van Bommel and J. R. Dahn, Chem Mater , 21 , 1500 (2009). Figure 1

Thermodynamic Analysis on the Coprecipitation of Ni-Co-Mn Hydroxide

Preparation and Thermal Decomposition Properties of NiMn Layered Double Hydroxides by an Oxidation Precipitation Method

Structure and Electrochemical Performance of Mn-Substituted Nickel Hydroxide

Synthesis, Crystal structure and thermal reactivity of [(N2H5)2Mn0.20Ni0.80(C2O4)2](H2O)2: A novel precursor to nickel-manganese oxide

Low Temperature Electrochemical Properties of LaNi4.6−xMn0.4Mx (m=fe or Co) and Effect of Oxide Layer on EIS Responses in Metal Hydride Electrodes

Formation of dispersive NiO nano-particles via hydrothermal modification

Evolution of Nickel, Manganese, and Cobalt Hydroxide Precursor for Li-Ion Battery Cathode Materials in Co-Precipitation Reactions

Thermodynamics of the Metal Carbonates and Bicarbonates of Mn, Co, Ni, Cu, and Zn Relevant to Mineral Energetics.

Thermodynamics adsorption of heavy metal ions Pb2+, Cd2+ and Cu2+ on hydrothermal δ-MnO2

Synthesis and Electrochemical Properties of Li[Ni X Co Y Mn 1− X − Y ]O 2 ( X, Y = 2/8, 3/8) Cathode Materials for Lithium Ion Batteries

Thermodynamic Analysis on the Preparation of Mn-Zn Soft Magnetic Ferrite Precursor by Coprecipitation Method

Establishing efficient toluene elimination over cobalt-manganese bimetallic oxides via constructing strong Co–Mn interaction

High Rate Performances of the Cathode Material Lini1/3co1/3mn1/3o2 Synthesized Using Low Temperature Hydroxide Precipitation

Synthesis and Characterization of M-doped Li1.05Co0.3Ni0.35Mn0.3O2 (M=Zn, Fe, Ti, Zr) Cathode Materials for Lithium ion Battery

Effect of Mn substitution on the microstructure of (MgCoNiZnCu)O powder and its electrochemical performance as an anode material

Studies on the Low-Heating Solid-State Reaction Method to Synthesize Lini1/3co1/3mn1/3o2 Cathode Materials

Comparative Thermal Kinetic Analysis Of Nickel Hydroxide Nanoparticles Through Chemical Precipitation And Sol–Gel Routes

Structure, Electrochemical Properties, and Thermal Stability Studies of Li[Ni[sub 0.2]co[sub 0.6]mn[sub 0.2]]o[sub 2]

General Synthesis and Phase Control of Metal Molybdate Hydrates MMoO4·nH2O (M = Co, Ni, Mn, N = 0, 3/4, 1) Nano/Microcrystals by a Hydrothermal Approach: Magnetic, Photocatalytic, and Electrochemical Properties

Preparation and Study of Spherical Nickel Hydroxide Coated by Cobalt Oxy-Hydroxide

Relationship between Surface Hydroxyl Complexation and Equi-Acidity Point pH of MnO 2 and Its Adsorption for Co 2+ and Ni 2+