Abstract:There is abundant of vibration energy in environment. Using piezoelectric energy harvesters to power ultra-low power wireless sensors has become a hot topic in recent years. Most piezoelectric energy harvesters have satisfactory output only at one resonant frequency, while once the external excitation frequency deviates from the resonant frequency, the voltage output will drop significantly. Therefore, this paper proposes a bridge-shaped piezoelectric energy harvester to broaden the frequency band for energy harvesting, and the harvester can adaptively adjust the natural frequency of the system to match the external excitation. Based on the two-dimensional nonlinear Euler–Bernoulli beam hypothesis and the Hamilton principle, the distributed-parameter dynamic model of the nonlinear energy harvesting system is set up. By use of variation operator and nondimensionalization, we derive the dimensionless electromechanical coupling equations. With the harmonic balance method, the approximate equations for calculating voltage amplitude and average power are derived. And then the model is numerically solved and analyzed by considering the influence of excitation frequency, excitation amplitude, mass position and load on the output performance of the bridge-type piezoelectric energy harvester. Finally, various comprehensive experiments are performed to verify the results of simulation, and the dynamic effects of the moving mass on the output characteristics are studied. It can be noted that the moving mass can improve the voltage output of the bridge type energy harvester by changing the resonant frequency of the bridge-type piezoelectric energy harvester and impacting the piezoelectric beam. The proposed vibration energy collection device can adaptively tune the resonant frequency and has practical value in engineering.

Optimal Locations of Piezoelectric Patch on Wideband Random Point-Driven Beam for Energy Harvesting

Energy Harvesting By Dynamic Unstability And Internal Resonance For Piezoelectric Beam

Harvesting Weak Vibration Energy by Integrating Piezoelectric Inverted Beam and Pendulum

Promote Performance of Vibration Energy Harvesting by Amplified Inertial Force and Clamped Piezoelectric Beams

A Collision Impact Based Energy Harvester Using Piezoelectric Polyline Beams with Electret Coupling

Hybrid Vibration Energy Harvesting Based on Piezoelectric Polyline Beams with Electret Coupling

Vibration Analysis and Distributed Piezoelectric Energy Harvester Design for the L-shaped Beam

Promote Efficiency of Harvesting Vibration Energy by Tailoring Potential Energy with Addition of Magnets

Nonlinear Dynamics of a Pendulum-Beam Coupling Piezoelectric Energy Harvesting System

A Broadband Zigzag-Shaped Energy Harvester for Both Wind Energy and Vibration Energy: Modeling and Experimental Verification

Analytical Modelling and Optimization of a Piezoelectric Cantilever Energy Harvester with In-Span Attachment

Improving the Performance of Vibration Energy Harvesting from Weak Excitations by a Lever-Type Mechanism

Piezoelectric vibration energy harvesting with asymmetric hybrid bracing beam

Energy harvesting of beam vibration based on piezoelectric stacks

A piezoelectric energy harvester with increased bandwidth based on beam flexural vibrations in perpendicular directions.

An L-shaped and Bending-Torsion Coupled Beam for Self-Adaptive Vibration Energy Harvesting

Simulation and Experiment on Bridge-Shaped Nonlinear Piezoelectric Vibration Energy Harvester

Energy Harvesting Characteristics of Preloaded Piezoelectric Beams

An Optimal Piezoelectric Beam for Acoustic Energy Harvesting

Modeling and Experiment of a V-Shaped Piezoelectric Energy Harvester

Design and experiment of wideband piezoelectric vibration energy harvester