Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A 12.5gbps Dual Loop Quarter Rate Cdr Using Lock Detecting Technique In 55nm Cmos Process

A 12.5gbps Dual Loop CDR with Multi-band VCO and Novel Frequency Band Switch

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A Half Rate CDR with DCD Cleaning Up and Quadrature Clock Calibration for 20gbps 60ghz Communication in 65nm CMOS.

A 10Gbps CDR based on phase interpolator for source synchronous receiver in 65nm CMOS

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A Clock and Data Recovery Circuit for 3.125gb/s RapidIO SerDes

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A 5/10 Gb/s Dual-Mode NRZ/PAM4 CDR in 65-Nm CMOS

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 48mw 15-to-28gb/s Source-Synchronous Receiver with Adaptive DFE Using Hybrid Alternate Clock Scheme and Baud-Rate CDR in 65nm CMOS.

A 781mbps-5gbps Dll-Based Cdr With Starting-Control Circuit

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 28gbps Reference-less VCO Based CDR with Separate Proportional Path Technology in 65nm CMOS

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition