An investigation of tool temperature in end milling considering the flank wear effect

Di Cui,Dinghua Zhang,Baohai Wu,Ming Luo

DOI: https://doi.org/10.1016/j.ijmecsci.2017.07.027

IF: 7.3

2017-01-01

International Journal of Mechanical Sciences

Abstract:•A new analytical model for predicting tool temperature in end milling considering flank wear is presented, which was rarely taken into account in previous temperature modeling in milling.•The temperature model of tool in milling proposed in this paper is able to predict the temperature of fresh or worn tool accurately, though there is negligible difference between theoretical and measurement results.•The heat partition on tool-chip interface gradually increases with the immersion angle of tool rise. At same cutting speed, it can be found that the partition increases with feed per tooth. However, when the cutting speed improves, it decreases at same feed per tooth. For heat partition on flank face, the flank wear has great effect on it.•It is found that flank wear has great effect on tool temperature in milling of Ti6Al4V, but this influence does not become larger with the flank wear growth. The tool temperature begins to rise at high rate, then becomes steady state, i.e. temperature rise slowly, until reaches the peak value. Comparing the temperature peak value at all cutting parameters, tool temperature increases when the cutting speed or feed per tooth rises, and is more affected by feed per tooth.